WPI Biological Signals Amplifier, Инструкция по эксплуатации, Страница: 6 / 16

2 World Precision Instruments
The amplifier contains four modules: two for recording fluid pressures (perfusion or
aortic, pulse pressure or LVP), one for recording the temperature of the perfusate and
tissue, and one for recording ECG signals or surface potentials.
The main switch and fuses of the 220/110 V power supplies are located on the back
panel of each rack. Input and output sockets are also found on the back panels.
Operation switches and indicators are on the front panels.
Parts List
After unpacking, verify that there is no visible damage to the instrument. Verify that
all items are included:
(1) Biological Signal Amplifier with:
(2) HG AMP-02 pressure amplifiers
(1) TH AMP-06 temperature amplifier
(1) ECG AMP-03 biopotential signal amplifier
(2) Fluid pressure sensors with Canon (D-sub) 9-pin connectors
(1) Temperature sensor with microphone jack connector
(3) Microphone jack to BNC output cables
(1) Power cable
(1) Instruction Manual
ECG or biopotential electrode and lead cable are not included with this system.
Please contact WPI at sales@wpiinc.com or 941.371.1003 to speak with one of our
representatives regarding the type of electrodes needed to record the biopotentials
of interest.
Unpacking
Upon receipt of this instrument, make a thorough inspection of the contents and
check for possible damage. Missing cartons or obvious damage to cartons should be
noted on the delivery receipt before signing. Concealed damage should be reported
at once to the carrier and an inspection requested. Please read the section entitled
“Claims and Returns” on page 11 of this manual. Please contact WPI Customer
Service if any parts are missing at 941.371.1003 or customerservice@wpiinc.com.
Returns: Do not return any goods to WPI without obtaining prior approval (RMA
# required) and instructions from WPI’s Returns Department. Goods returned
(unauthorized) by collect freight may be refused. If a return shipment is necessary,
use the original container, if possible. If the original container is not available, use a
suitable substitute that is rigid and of adequate size. Wrap the instrument in paper
or plastic surrounded with at least 100mm (four inches) of shock absorbing material.
For further details, please read the section entitled “Claims and Returns” on page
11 of this manual.