Rev 17.2/12-21
MT-10TDC-HV-C: #35094
21
T
O
R
ELEASE
THE
P
ADS
FROM
THE
L
OAD
Make sure load is at rest and fully supported before releasing
vacuum pads.
Do not move lifter until pads release completely, because such movement could
result in load damage or personal injury.
1)
1A
Place the vacuum control valve lever
perpendicular
to the vacuum line (ie, in the
“release” position —
, fig. 1A). After the
vacuum pads release completely, the lifter
can be attached immediately to another
load.
1
Do not attempt to lift
load while control valve
is in “release” position
(
)
.
Note: Although the low vacuum warning light and
the vacuum pump may turn off when the control
valve in the “release” position
(
)
, this does
not
mean the lifter is ready to lift a load.
2) Before you lift another load, perform the Every-Lift Inspection (see
).
A
FTER
U
SING
THE
L
IFTER
1)
1B
Place the power switch in the “off” position (
— fig. 1B), and
leave the vacuum control valve lever in the “release” position —
).
2) Disconnect the vacuum line leading from the vacuum package (see
).
3) Charge the battery after each workday as needed (see
2
1..... If the next lift is not imminent, turn off the vacuum package until ready to lift another load (see “A
FTER
U
SING
THE
L
IFTER
”).
2..... To maximize battery life, charge it promptly after each use.
OPERATION
Содержание MT1010TDC
Страница 2: ...MT 10TDC HV C 35094 Rev 17 2 12 21 2 ...
Страница 6: ...MT 10TDC HV C 35094 Rev 17 2 12 21 4 SPECIFICATIONS ...
Страница 36: ...MT 10TDC HV C 35094 Rev 17 2 12 21 34 ...
Страница 37: ...Rev 17 2 12 21 MT 10TDC HV C 35094 35 ...
