WPG MRPTHD1211LAC, Руководство по эксплуатации

Страница: 10 / 42

MRPTHD-AC: #35066 Rev 1.0/2-21 8
ASSEMBLY
1) Remove all shipping materials and save them with the shipping container for future use.
2)
Make sure power source has
ground fault circuit interrupter.
Connect the power cable:
2.1)
Wiring must be done by
qualified personnel, taking all
appropriate safety precautions.
Wire the female connector provided to
an appropriate power source, as
indicated on the label attached.
Without adequate power, lifter
could release load, resulting in
load damage and personal injury.
Note: Brown-outs, over-taxed generators,
extension cords and other conditions can
reduce power at the lifter.
2.2) Route the power cable so that it does not become tangled during operation.
2.3) Plug in the power cable:
2A 2B
Insert
the power cable’s male
connector into the female
connector and twist to secure
them together (fig. 2A-B).
3)
3A
As needed, adjust the lift point position (fig. 3A):
1
3.1) Remove the cotter pins that secure the mounting
pins. Then remove the mounting pins.
3.2) Move the lift point to the position that provides
the best hang angle for the load.
3.3) Reinstall the mounting pins, and secure them with
the cotter pins.
Make sure all hardware for adjustable
lift point is installed securely before
using lifter.
Failure to install adjustable lift point hardware
securely can result in load damage or personal injury.
1..... Moving the lift point forward (away from operator) helps keep the hang angle vertical while the lifter is loaded ; moving the lift spool rearward
(towards operator) helps keep the hang angle vertical while the lifter is unloaded .