Woxcon IPA100, Руководство пользователя

Страница: 24 / 60

4K IP Streaming Extender
18
l
Ensure that the network switch has been properly configured.
l
Confirm that the display can support the input source resolution.
l
Verify that the HDMI cable being used is of good quality. This is particularly
important for high-bandwidths of up to 18Gbps with 4K@60Hz resolution, requiring
a "HDMI Premium High Speed" cable.
To assign a different input source to a Receiver (RX), repeat the steps mentioned
above, dragging a different TX over an RX to associate the receiver itself to the new
source device.
Note: For "Fast Switch Mode" and "Genlock Scaling", please refer to "Genlock Mode".
5.4.2 Sending Single Source to All RX Devices
To send the same source signal input to all receivers at the same time, simply drag and
drop the TX unit that the desired source is connected to onto the blue tile in the
Receiver (RX) section, labeled "All Displays".
Comment: To verify, which RX and TX are joined together, left-click on the Receiver
(RX) or Transmitter (TX) tile you want to see the connection status for. All the joined
tiles will be highlighted in blue.
5.4.3 Stopping/Starting Video
To stop video being transmitted from a Transmitter (TX), right click the gear icon of the
respective Transmitter (TX) and select "Stop Video".
To start or restart a video transmission, right click the gear icon of the respective
Transmitter (TX) and select "Start Video".
5.4.4 Disconnecting Source from RX
To disconnect a Receiver (RX) from a Transmitter (TX) source, right click the gear icon
of the respective RX tile and select "Leave Video Channel".
5.4.5 Preset Management
To rename a preset, delete a stored preset or save the current video switching setting,
recall a saved preset by selecting preset #1~9 and click the gear icon to select the