1.
Use the supplied self-tapping screws to install the support bracket to the vehicle.
2. Set the transceiver in the bracket, then insert the supplied combined screws and tighten, insure that
the screws are fastened tightly. This will insure the support bracket and the transceiver do not get bumped
lose when the vehicle hits bumps or shakes.
04
Pre-use installation
Transceiver installation
Choose a safe place inside your vehicle, one which would to the greatest extent reduce possible harm
to passengers inside the car while the car is moving. It is recommended to install the transceiver on the
lower part of the front meter gauge, it will prevent the transceiver from colliding with the driver in the in-
stance of emergency or sudden braking. Install the transceiver in an area with good ventilation and avoid
installing in a place with direct contact with the sun.
Self-Tapping screws (4)
Specification: 5x16
Screw washer
Combined screws (4)
Specification: M4x6.5
3.
Use every screw slot along the side of the support bracket, you can set the transceiver to be insta-
lled at a different angle.
05
