Worx WX646, Руководство пользователя

Страница: 7 / 76

Palm sander EN
7 6 PB 7
Do not allow your sander to remain in the
same position otherwise you will remove
material and create and uneven surface.
6. CHANGE THE BASES (See Fig. C, D)
1) Remove the 5 Phillips head screws holding
the triangular base.
2) Replace triangular base by fastening the
detail sanding attachment to base position.
3) Fix it by 5 screws.
4) Similar process is conducted when detail
sanding attachment is changed to triangular
base.
7. ATTACH SANDING SHEETS AND PADS
(See Fig. E)
This sander features an easy hook and loop
accessory fastening system for quick changing
without clamps.
1) Unplug the sander.
2) Carefully center the sanding sheet (A) or
pad over the base (3/4) to be used. Line up the
tip of the sanding sheet (B) or pad with the tip
of the base (C).
3) Press the sheet or pad firmly in place.
4) To remove sheet or pad, simply pull it off.
WARNING:
Failure to unplug the
sander could result in accidental starting
causing possible serious personal injury.
8. SANDING WITH EITHER BASE
(See Fig. F)
Always hold the sander as shown in Fig F.
Move the sander in long, sweeping strokes
across the sanding surface. Light pressure is
needed for sanding, polishing and scrubbing.
Let the sander do the work. Always check your
work. This sander removes material quickly.
IMPORTANT:
Applying excessive
pressure will slow the sander and produce
unsatisfactory results.
WORK HINTS FOR YOUR
PALM SANDER
If your power tool becomes too hot, run no
load for 2-3 minutes to cool the motor.
Always ensure the work-piece is firmly held or
clamped to prevent movement.
Any movement of the material may affect the
quality of the sanding finish.
Start your sander before sanding and turn off
only after stopping sanding. For best results
sand wood in the direction of the grit.
Do not start sanding without sandpaper fitted.
Do not allow the sandpaper to wear away, it
will damage the base-plate. The guarantee
does not cover base-plate wear and tear.
Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit
for the final surfaces. If necessary, first make a
test on scrap material.
Use only good quality sandpaper.
The sanding efficiency is controlled by the
sandpaper not the amount of force you apply
to the tool. Excessive force will reduce the
sanding efficiency and cause motor overload.
Replacing the sanding paper regularly will
maintain optimum sanding efficiency.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.