Worx WX437, Инструкция по безопасности и эксплуатации, Страница: 16 / 20

16
Compact Circular Saw
WX437
WX437.X
PLUG REPLACEMENT
(ONLY FOR REWIRABLE PLUG
OF UK & IRELAND)
If you need to replace the fitted plug then follow the
instructions below.
IMPORTANT
The wires in the mains lead are colored in accordance with
the following code:
Blue = Neutral
Brown = Live
As the colors of the wires in the mains lead of this appliance
may not correspond with the colored markings identifying
the terminals in your plug, proceed as follows. The wire which
is colored blue must be connected to the terminal which
is marked with N. The wire which is colored brown must be
connected to the terminal which is marked with L.
WA R N I N G !
Never connect live or neutral wires to the earth terminal
of the plug. Only fit an approved BS1363/A plug and the
correct rated current fuse which is used in the plug.
NOTE: If a moulded plug is fitted and has to be removed
take great care in disposing of the plug and severed cable,
it must be destroyed to prevent engaging into a socket.
Connec t
Blue to N
(neutral)
Outer sleeve
firmly clamped
Cable grip
Brown L (live)
Fuse
TROUBLE SHOOTING
Symptom Possible Causes Possible Solution
Tool will not start when operating the on/
off switch.
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn down
Check to make sure power cord is connected
well into a working outlet.
Unplug the power cord. Replace it using a
qualified maintenance person.
Replace the carbon brush using a qualified
maintenance person.
Cutting depth is less than that is set.
Sawdust accumulated at the rear of
the base. Shake out sawdust. Consider connecting a
vacuum for dust collection.
Blade spins or slips
Blade is not tightly engaged with the
spindle.
Remove the blade, and reassemble it as
described in
Mounting and Removing the
Blade section.
Blade will not cut a straight line.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided properly. Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Blade kicks back when beginning a cut Blade is not spinning fast enough
Allow the saw blade to reach full speed prior
to beginning a cut in the material.