Worx WX437, Инструкция по безопасности и эксплуатации, Страница: 15 / 20

15
Compact Circular Saw
WX437
WX437.X
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE:
The tool is intended for ripping and cross-cutting wood and
other materials in straight cutting lines, while resting firmly
on the work piece.
ASSEMBLY AND OPERATION
Action Figure
Mounting and Removing the Blade
NOTE: Lock or loose the blade bolt,
the spindle lock button should be
pressed.
WARNING: Always remove
the battery before changing
the blade!
See Fig. A
Safety switch and On/Off trigger
WARNING : To avoid cutting
injury from the sharp blade,
please don’t put your hands around
the Base Plate.
NOTE: Keep the dust adapter
connected to dust collecting device
when using the tool.
See Fig. B
Rip and Cross Cutting
NOTE : The cutting line of saw blade
is aligned with the cutting mark 0°.
See Fig. C1, C2
Using the Laser Light Feature See Fig. D1, D2
Replacing Laser Batteries
See Fig.E1,
E2,E3
Parallel Guide See Fig. F1, F2
Adjusting the Cutting Depth See Fig. G1, G2
Adjusting the Cutting Angle
NOTE: The cutting line of saw blade
is aligned with the cutting mark 45°.
See Fig. H
Pocket cutting See Fig. I1, I2
Sawdust Removal See Fig. J
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting with
extreme force can significantly reduces the performance
capability of the tool and reduces the service life of the
saw blade. Sawing performance and cutting quality
depend essentially on the condition and the tooth count of
the saw blade. Therefore, use only sharp saw blades that
are suited for the material being cut.
Choice of blades: 24 teeth for general work, approx. 40
teeth for finer cuts, more than 40 teeth for very fine cuts
into delicate surfaces, diamond for tile, cement board, etc.
Only use saw blades recommended.
MAINTAIN TOOLS WITH CARE
Remove the plug from the socket before carrying out
any adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically and
if damaged, have repaired by authorized service facility.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Periodically clear dust and chips from guard and base to
ensure proper performance.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.