Worx WX178.1, Оригинальное руководство пользователя

Страница: 10 / 80

10
Lithium-Ion Cordless Drill/Driver EN
OPERATION
Forward/Reverse Rotation Switch
WARNING:
Never change
the direction of rotation
when the Chuck is rotating. Wait
until it has stopped!
See Fig. D1,
D2, D3
Function Mode Selection
Press the function button to select operation mode.
The button will illuminate in blue for a few seconds.
Depress the Variable Speed Switch (10) slightly to
illuminate the function button again.
Drive Mode with Safe drive
• When driving a screw, the tool
automatically stops as the screw
head becomes flush with surface
of workpiece. If a deeper screw is
desired, continue to depress the
Variable Speed Switch (9). The tool
will make slow rotations to drive
the screw deeper.
• Once the desired depth is
reached, release the Variable
Speed Switch (9).
NOTE: If the tool stops sooner
than desired, release the Variable
Speed Switch (9) and press it
again to reset the tool.
See Fig. E
Drill Mode See Fig. F
Pulse Assist
WARNING: Do not work for
long periods with the Pulse
Assist activated as the motor can
be overheated.
NOTE: Pulse Assist is very
effective to prevent stripping
screws, removing stubborn screws
and to prevent the bit tip from
walking when drilling on smooth
surfaces. When the Pulse Assist is
activated, it can be switched with
the drill/drive mode.
• Make sure the Forward/Reverse
Rotation Switch (4) is pushed
to the left or right and the Pulse
Assist is selected.
• Press the Variable Speed Switch
(10), the tool will begin to rotate at
a controllable pace.
See Fig. G
Variable Speed Switch
WARNING: Do not operate
for long periods at low
speed because excess heat will be
produced internally.
See Fig. H
Using the LED light
To turn on the light, press the
Variable Speed Switch (9) and
make sure the Forward/Reverse
Rotation Switch (4) is on right or
left position. When you release the
Variable Speed Switch (9), the light
will go off after a moment.
The LED Light is also a battery
capacity indicator. It will flash
when power gets low.
The tool and battery pack are
equipped with a protection
system. When the LED Light is
quickly flashing, the system will
automatically cut power to the
tool to extend battery life. The tool
will automatically stop during
operation if the tool and/or battery
pack are placed under one of the
following conditions:
• Overloaded: The tool is
operated in a manner that causes
it to draw an abnormally high
current. In this situation, release
the Variable Speed Switch on
the tool and stop the application
that caused the tool to become
overloaded. Then pull the Variable
Speed Switch again to restart.
• Overheated:
Under the
condition above, if the tool does
not start, the tool and Battery Pack
are overheated. Let the tool and
Battery Pack cool before pulling
the Variable Speed Switch again.
• Low battery voltage:
The
remaining Battery capacity is too
low and the tool will not operate.
Remove and recharge the Battery
Pack.
See Fig. H
TROUBLESHOOTING
1. WHY DOES THE DRILL NOT TURN ON WHEN
YOU PRESS THE SWITCH?
The Forward/Reverse Rotation Switch, which is on
top of the trigger, is positioned in the lock function.
Unlock the Forward/Reverse Rotation Switch by
putting it into the required rotation position. Push the
trigger and the drill will start to rotate.
2. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, and having not used a
Battery Pack (7) for a prolonged time will reduce the
Battery Pack working time. This can be corrected after
several charge and discharge operations by charging
& working with your drill. Heavy working conditions
such as large screws into hard wood will use up