Worx WX153, Инструкция по безопасности и эксплуатации

Страница: 22 / 25

6
Battery charger
WA3790 WA3791 WA3792 WA3713
CHARGING PROCEDURE
Note:
Before using the tool, read the
instruction book carefully.
1. CHARGING yoUR bAtteRy PACK
WARNING:
The charger and battery
pack are specifically designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because an electrical failure and hazard will
occur.
2. beFoRe USING yoUR CoRDleSS
tool
Your battery pack is UNCHARGED and you
must charge once before use. When you
charge the new battery or one which has not
been used for long periods of time, it may
not reach full charge until after you have
discharged it fully in use and recharge it
several times.
3. HoW to CHARGe yoUR bAtteRy
PACK
Connect the battery charger to the power
supply and the green light (2) will illuminate.
Then, Put the charger base on battery pack to
make connections and the light (2) will turn
into red to show charging has started. A fully
discharged battery will take several hours to
reach full charge. When charging is complete,
unplug the charger and remove the battery
pack.
Note:
LED indicator will not switch off when
battery is charged.
WARNING:
When battery charge runs
out after continuously use or exposure
to direct sunlight or heat, allow time for
the tool to cool down before re-charging to
achieve the full charge.
Note:
The charger will not automatically switch
off when the battery is full charged, and the
orange light indicator will remain on. Do not
leave your battery on charge continuously.
This may damage the battery cells.
If the battery pack is very hot you must
remove your battery pack from the charger
and allow your battery pack to cool first to
ambient temperature and then recharging
can be started. If you charge a second battery
pack immediately after the first one, then the
charger adapter can be overheated. Always
allow at least 15 minutes rest between battery
pack charging.
PROBLEM SOLUTION
1. I CANNot FIt tHe bAtteRy INto
tHe bAtteRy CHARGeR. WHy?
The battery can be inserted into the charger
only in one direction. Turn the battery around
until it can be inserted into the slot, the
orange LED light should turn on when the
battery is charging.
2. ReASoNS FoR DIFFeReNt
CHARGING tIMeS
Charging time problems, as above, and
having not used a battery pack for a
prolonged time will reduce the battery pack
working time. This can be corrected after
several charge and discharge operations by
charging & working with your drill. Heavy
working conditions such as large screws
into hard wood will use up the battery pack
energy faster than lighter working conditions.
Do not re-charge your battery pack below
0
o
C and above 30
o
C as this will affect
performance.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing
or maintenance.
Your tool requires no additional lubrication
or maintenance. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power
tool in a dry place.