Worx WU760, Руководство по эксплуатации

Страница: 8 / 84

8
the desired angle and retighten the fence bolts.
CLAMPING THE WORK PIECE (See Fig. C)
To ensure optimum work safety, the work piece must always be
firmly clamped.
Place the work piece against the fence of the angle stop. Slide the
clamping spindle against the work piece and clamp the work piece
firmly with the aid of the spindle handle.
Releasing the Work Piece
Loosen the spindle handle. Release the locking lever and pull the
clamping spindle away from the work piece.
OPERATING THE MACHINE
Switching On and Off (See Fig. D)
To
switch on
, slide the button
(21)
to the left. Then press the on/off
switch (20) and hold it depressed.
For safety reasons, the on/off switch of the machine cannot be
locked on but must remain depressed during operation.
To
switch off
the machine, release the on/off switch.
4
5
Use only cutting discs whose allowable speed is as high as the no
load speed of the machine.
Actuate the spindle lock only when the cutting disc is at a standstill.
Removing the Cutting Disc
Place the machine in the working position.
Swing the pendulum protection hood
(3) upwards to the stop.
Turn the hex head bolt
(19)
anticlockwise with the spanner
(14)
provided while pressing the spindle lock at the same time until it
engages.
Keeping the spindle lock depressed then unscrew the hex head bolt.
Remove the washer
(18)
and the clamping flange
(17)
.
Remove the cutting disc.
Installing the Cutting Disc
If necessary, clean all parts to be mounted.
Place the new cutting disc on the tool spindle
(16) so that the label
points away from the tool arm.
Place on the clamping flange, the washer and screw in the hex head
bolt.
Press the spindle lock until it engages and tighten the hex head bolt
clockwise.
Guide the pendulum protection hood back down.
ADJUSTING THE MITRE ANGLE
The mitre angle can be set in a range from 0° to 45°.
Often used angles are identified on the angle stop
(12) with
appropriate marking. The 0° and 45° positions are set at the end
stops.
Loosen the two fence bolts
(11 & 13)
with the spanner provided. Set
3