7
EN
IMPORTANT SAFETY INSTRUCTIONS.
KEEP FOR FUTURE REFERENCE.
Attention: read all safety warnings and all instructions for the safe operation of the machine. Failure to follow the warnings and
instructions may result in electric shock, fire and/or serious injury.
1. Landroid is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety
2. Children should be supervised to ensure that they do not play with Landroid
3. Landroid is only to be used with the power supply unit provided with it
Safety guidance before use
1. Read the instructions carefully. Make sure you understand the instructions and be familiar with the controls and the proper use of
Landroid
2. Never allow people unfamiliar with these instructions or children to use Landroid
3. The operator or user is responsible for accidents or hazards occurring to other people or their property
Preparation before use
1. Ensure the correct installation of boundary wire as instructed
2. Periodically inspect the area where Landroid is to be used and remove all stones, sticks, wires, bones, and other foreign objects
3. Periodically visually inspect to see that the blades, blade bolts and cutter assembly are not worn or damaged. Replace worn or
damaged blades and bolts in sets
4. Turn off Landroid, remove the battery, wear protectives gloves and take care when inspecting blades, as rotating one blade can
cause other blades to rotate
WARNING!
The lawnmower should not be operated without the guard in place
Safe Operation
1. Never operate the appliance with defective guards or without the guard in place
2. Do not put hands or feet near rotating parts
3. Never pick up or carry Landroid while it is running
4. Turn off the machine and remove the battery before clearing a blockage and before checking, cleaning or working on Landroid
5. It is not permitted to modify the original design of Landroid. All modifications are made at your own risk
6. Start Landroid according to the instructions. When the power key is switched on, make sure you keep your hands and feet away
from the rotating blades.
7. Never lift up Landroid or carry it when the power is switched on
8. Do not put anything on top of Landroid or its charging station
9. Do not allow Landroid to be used with a defective blade disc or body. Neither should it be used with defective blades, screws, nuts
or cables
10.Switch off Landroid when you do not intend to use it for a long period of time
11.Landroid can only start when the power is switched on and the correct PIN code has been entered
12.Avoid using Landroid in bad weather conditions especially when there is a risk of lightning
13.Do not touch moving hazardous parts before these have come to a complete stop
14.Do not leave Landroid to operate unattended if you know that there are pets, children or people in the vicinity
MAINTENANCE AND STORAGE
Attention:
When the mower is turned upside down the power key must always be switched off. The power key should be
switched off and the battery removed during all work on the mower’s under frame, such as cleaning or replacing the blades.
1. Do not wash Landroid with a pressure washer—due to the high pressure, water can go inside Landroid and damage the electronic
circuit
2. To avoid injuries, wear protective gloves when replacing the blades
3. Keep all nuts, bolts and screws tight to be sure Landroid is in safe working condition
4. Inspect Landroid each week and replace worn or damaged parts for safety
5. Ensure that only replacement blades of the right type are used
6. Ensure that batteries are charged with Landroid’s charging station. Incorrect use may result in electric shock or overheating of the
battery
7. Servicing of Landroid should be according to manufacturers’ instructions
Recommendation
Please only connect Landroid and/or its peripherals to a supply circuit protected by a residual current device (RCD) with a tripping
current of not more than 30 mA.
