Worx WG891E, Руководство пользователя

Страница: 13 / 144

13 12 13 12
Cordless Li-ion handy saw
EN
gENERAL CuTTINg (Fig h1, h2)
NOTE:
1. Always use a blade suited to the material
and material thickness to be cut. The quality
of cut will improve as the number of blade
teeth increase.
2. Always ensure the workpiece is firmly held
or clamped to prevent movement. Support
large panels close to the cut line. Any
movement of the material may affect the
quality of the cut.
3. The blade cuts on the upward stroke and
may chip the uppermost surface or edges
of your work piece when cutting, ensure
your uppermost surface is a non-visible
surface when your work is finished.
OPERATION:
1. Mark the line of cut, clearly before your
cutting.
2. Do not force the tool. Place the steel base
(12) firmly on the workpiece while cutting.
Use only enough steady pressure on the
blade to keep the saw cutting.
3. Reduce the pressure as the blade comes to
the end of the cut.
4. Allow the saw to come to a complete stop
when before removing the blade from the
workpiece.
TREE TRImmINg
Use wood blade when cutting tree branches.
Cut close to trunk of tree to decrease
movement of the branch being cut.
PLuNgE CuTTINg (FIg I1, I2, I3):
Your WORX Handy saw can plunge cutting
directly into surfaces that cannot be cut from
edge. Plunge cutting may be used only on
soft materials such as wood, aerated concrete,
gypsum plaster boards, etc..
wARNINg: Do not make plunge
cuts in metal materials.
1. Mark the pocket or internal hole to be cut
out.
2. Angle the saw so that the steel base (12) is
resting on the work surface (See I1).
3. With the blade just above the workpiece,
do not touch blade to workpiece until saw
reaches full operating speed.
4. With the blade guard held firmly against
the work surface, start a slow but controlled
upward swing of the saw. (See I2)
5. The blade will cut into and through the
material. Always ensure the blade is
completely through the material before
cutting the remainder of the pocket.(See I3)
mETAL CuTTINg
Use a finer tooth blade for ferrous metals and
a coarse tooth blade for non-ferrous metals.
When cutting thin sheet metals always clamp
steel on both sides of the sheet to reduce
vibration or tearing of the sheet metal. Do not
force the cutting blade when cutting thin metal
or sheet steel as they are harder materials and
will take longer to cut. Excessive blade force
may reduce the life of the blade or damage
the motor. To reduce heat during metal cutting,
add a little lubricant along the cutting line.
MAINTENANCE
Remove the battery pack from the tool
before carrying out any adjustment,
servicing or maintenance.
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your
tool. Never use water or chemical cleaners to
clean your tool. Wipe clean with a dry cloth.
Always store your tool in a dry place. Keep the
motor ventilation slots clean. Keep all working
controls free of dust.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.