Worx WG780E, Инструкция по эксплуатации

Страница: 12 / 160

3 in 1 Cordless lawn mower EN
12
3. FITTING/REMOVING BATTERY
(See E1, E2)
Removing battery
Pull out the battery connector, then rotate the
battery locking knob counter-clockwise and
then use the battery handle to remove the
battery.
NOTE:
Be careful not to drop the battery onto
your foot or on the ground when removing it.
Fitting battery
Put the battery into the battery container, press
the battery connector and then rotate the
battery locking knob.
4. HANDLE ADJUSTMENT (See F)
The upper handle can be adjusted to 3
different height positions. Release the locking
cam lever, set the upper handle to one of the
three height positions, and make sure to insert
the pin (c) into the hole. Then reset the locking
cam lever.
NOTE:
Always check that the upper handle is
fixed firmly.
5. INSTALLING THE GRASS BAG
(See G1,G2 & G3)
Fitting
1. Turn the mower off, wait until blade stops
and remove safety key.
2. Raise the safety flap and hold it up,
ensure that the mulching insert has been
removed.
3. Pick up the grass bag by the handle, and
position grass bag on the lower hooks (a)
on the mower deck.
4. Release the safety guard to lock the grass
bag into position. Ensure the grass bag is
installed securely.
NOTE:
Depress the grass bag slightly to
ensure that it is completely installed.
Removing/emptying
Lift the safety guard and hold it up. The grass
bag will drop automatically.
6. ADJUSTING THE CUTTING HEIGHT
(See H)
WARNING!
Stop, release switch lever
and wait until the motor stops before
adjusting height. The blades continue to rotate
after the machine is switched off, a rotating
blade can cause injury.
CAUTION: Do not touch rotating blades.
For the first cutting of the season, a high
cutting adjustment should be selected.
The lawnmower can be set to 6 cutting heights
between 38mm and 88mm. For this purpose,
move the cutting height adjustment lever
outwards then adjust to the preferred position.
OPERATION
1. STARTING AND STOPPING (See I)
WARNING!
The blade continues
to rotate for a few seconds after the
machine is switched off. Allow the motor/blade
to stop rotating before switching “on” again.
Do not rapidly switch off and on.
Starting:
4/34!24%.').%
)NSERT+EY
0USH+EY
0ULLBAR
1. Insert safety key into the housing of the
switch box.
2. Push down the key, until safety key is fully
seated inside housing.
3. Press and hold the safety key, squeeze the
switch lever bar towards the handle and
the mower will start.
4. Release the safety key.
Stopping
Release the switch lever bar.
2. BATTERY STATUS LED’S (See J)
NOTE: Battery status LED’s are not active
in charging mode. The status LED’s will
indicate the battery condition when the
button on the battery is pressed.
The LED’s constantly senses and displays the
battery condition as follows:
Press the button “PRESS”, the light button is
illuminated.