3-in-1 Cordless lawn mower EN
15
4. While holding the Grass Collection Bag in
position lower the safety flap into its final
position. It should rest on top of the grass
bag with the tabs of the Grass Collection
Bag being inserted into the Safety Flap.
Ensure the Safety Flap locks securely into
position with the Grass Collection Bag (See
Fig. D3) .
NOTE:
The two parts should smoothly
slide together with little force. They WILL
NOT “click” together.
NOTE:
Press down on the Grass Collection
Bag (5) slightly to ensure that it is completely
installed.
4. rEmOviNg/EmPTyiNg THE grass
COllECTiON bag
1) Switch the mower off, remove the Safety
Key (6) and wait until the mower blade has
stopped.
2) Hold the grass bag handle.
3) Raise the Safety Flap (9) upward and hold
it in the upward position until the Grass
Collection Bag is removed (See Fig. D1).
warNiNg!
Before each use, always
check that the safety flap closes securely
over the rear discharge chute. Never lift
the Safety Flap when the lawn mower is in
operation. The Blade(16) must be completely
at rest before handling the safety flap.
5. fiTTiNg/rEmOviNg THE baTTEry
PaCK (see fig. E1, E2, E3, E4)
rEmOviNg baTTEry PaCK (10)
1) While gripping the battery handle lift it
straight upward without twisting or turning
it (See Fig. E1) .
fiTTiNg baTTEry PaCK
1) Locate the front and rear of the battery (See
Fig. E2).
2) Lower the battery into position. (See Fig. E3).
NOTE: for a secure fit, make sure the
battery tray is free of debris and the
contacts on the battery and in the
battery tray are clean (use a dry cloth
to clean) (see fig. E4).
When fitting or removing the battery be
careful not to drop the battery onto your foot
or the ground.
OPERATION
1. sTarTiNg aNd sTOPPiNg (see fig.
f1, f2, f3)
warNiNg! The blade(16) continues
to rotate for a few seconds after
the machine is switched off. allow the
motor/blade to stop rotating before
switching “on” again. do not rapidly
switch off and on.
sTarTiNg
1) Insert Safety Key (6) into the housing of the
switch box (See Fig. F1) .
2) Slide the Safety Key to the right and hold in
position (See Fig. F2) .
3) Pull the Switch Lever (2) towards the
handle bar and the mower will start (See
Fig. F3) .
4) Release the Safety Key (6) and begin mowing.
NOTE:
The Safety Key will stay in the “on”
position as long as the operator holds the
lever tightly against the handlebar.
sTOPPiNg
Release the Switch Lever and remove the
Safety Key.
2. iNsTalliNg mUlCH PlUg (14) (see
fig. g)
1) Turn the mower off, wait until the blade
stops and remove the Safety Key (6).
2) Raise the Safety Flap and hold it up.
3) Slide the mulching insert into the discharge
opening until it is firmly in contact with the
deck.
4) Release Safety Flap and ensure it is
properly closed.
3.rEmOviNg mUlCH PlUg(14) (see fig. g)
Remove the mulch plug when you desire to
either collect grass or discharge grass from
the rear of the mower.
1) Shut the mower off, wait until the blade
stops and remove the Safety Key (6).
2) Raise the Safety Flap (9) and hold it in the
up position.
3) Grasp the handle on the Mulch Plug then
lift upward and pull it out.
4) Release the Safety Flap and ensure it is
properly closed.
Содержание WG775
