Worx WG606, Руководство пользователя

Страница: 10 / 24

10
Electric Pressure Washer EN
Protection class
/II
ACCESSORIES
WG606
Nozzle (25° / 40° / soap ) 3
Turbo Nozzle 1
25ft Hose 1
Declogging needle 1
We recommend that you purchase your accessories listed
in the above list from the same store that sold you the tool.
Refer to the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The electric high pressure washer is intended for residen-
tial cleaning projects-from porch to patio, driveways and
decks, boats, pavers, bricks, BBQs and more.
ASSEMBLY & OPERATION
ACTION FIGURE
ASSEMBLY
Lifting the telescoping handle See Fig. A
Attaching the lance
NOTE : when attaching, align the two
projections on the lance with the
grooves on the wand.
See Fig. B1,
B2
Attaching the wand holder See Fig. C1,
C2
Screwing & Unscrewing the high pres-
sure hose
NOTE: Make sure the hose is tightly
connected.
NOTE: For convenience of unscrewing
the hose, please pull the trigger to drain
water from wand when operation is
completed and on/off switch is in “O”
position.
See Fig. D1,
D2, D3, D4
Attaching the garden hose
Connect one end of the home garden
hose (not supplied) to the adapter and
another end to waterspout.
See Fig. E
OPERATION
Extension cord
It is not recommended to use the
extension cord. If necessary, ensure
the plug and extension cord con-
nection is on an elevated surface
that does not contact the water
area.
See Fig. F
GFCI plug test
Press “test”, the light will be out.
Press “reset”, the power regains and the
light will illuminate.
NOTE: To keep good operation of
GFCI, please implement it once a
month.
See Fig. G
Start/stop
Turn on the water supply tap. Connect
the washer to the power supply and
turn the on/off switch to “I ” position.
Then press trigger.
NOTE: Before pressing trigger, push
the lock-out down into the trigger.
WARNING: Do not start the
machine without connecting
and turning on the water supply
because it may cause damage to
high pressure seals and reduce the
service life of pump.
See Fig. H1,
H2
Release the trigger and turn the on/
off switch to “O” position. Turn Off the
water supply tap.
NOTE: When not in use, push the
lock-out up until it clicks into the
slot.
See Fig. I1, I2
Select the right nozzles
Select the suitable nozzle for different
cleaning jobs.
Nozzle 25
0
(green) is applicable for
cleaning on concrete, bricks and
masonry.
Nozzle 40
O
(white) is applicable for
cleaning on wooden and other soft
objects.
The soap nozzle is applicable for soap-
ing while other nozzles cannot be used
to do it.
Turbo nozzle is applicable for cleaning
on concrete, bricks and masonry.
WARNING: Do not change the
nozzle pattern when the tool is
powered on.
See Fig. J