Worx WG601, Руководство пользователя

Страница: 11 / 24

13A Electric Pressure Washer EN
11
ATTACHMENT OF ACCESSORIES
Note : Do not attempt to use the washer with no lance or accessories attached.
Soap bottle
Soap bottle provides detergent suds for deeper cleaning of dirt. It is used in conjunction with wand. (See Fig. K)
MAINTENANCE
Remove plug from the socket before carrying out any adjustment, servicing or maintenance.
Inspect the product for damaged or worn parts before each use. Do not operate it if you find damaged or worn
parts. Contact your supplier or the manufacturer for replacement parts.
Power cord maintenance
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Pump maintenance
Inspect the pump frequently whether any leaking occurs around the pump seal. If leaking occurs, please contact
service center for repair.
Nozzle maintenance
Remove the nozzle from the lance, then remove any possible obstructions using the included declogging
needle(See Fig. J) .Then use a garden hose to rinse the nozzle by backwashing.
WARNING
: Any other servicing should be performed by an authorized service representative.
STORAGE
1. Disconnect the water source. Turn on the pressure washers for a few seconds until the remaining water flows
out. Then turn it off quickly.
2. Unplug the power supply.
3. Disconnect the high pressure hose and the garden hose (not supplied),and coil high pressure hose for storage.
4. Store in a frost free area with a temperature above 0°C(32°F).
TROUBLESHOOTING
Symptom Possible causes Solution
Machine does not
start when the switch
is in” ON/I”position.
Power cord is not plugged in. Plug in power cord.
Socket is defective
.
Check or replace plug, socket, fuses.
GFCI is triggered. Press reset on GFCI plug.
Machine pressure is
not consistent.
Pump is faulty. Contact service center .
Air in line. Remove the nozzle, turn on the machine for a while
and install the nozzle back.
Water inlet adapter is clogged
or dirty.
Remove the adapter, rinse it with water and put is back.
The pressure of
the pump is not
adequate
Water supply is Insufficient. Open water source completely.
Water supply is restricted. Check If the water hose kinks or leaks.
Diameter of garden hose is too
small.
Replace with right garden hose .
Leak or kick in hose . Replace hose or untie kinks in hose.
Lance leaks O-ring needs to be replaced . Replace o-ring .If the problem is not solved ,contact
service center to buy a new lance.