13
12
High pressure cleaner WG600E WG601E WG602E
connection to the power supply
1. Check the voltage. The voltage must
comply with the information on the rating
label at the beginning of this manual.
2. Make sure that the on/off switch on the
front of machine is in the OFF position.
3. Connect the plug with a suitable socket or
extension cord.
your product is now fully assembled and
ready for use.
The trigger gun is equipped with a trigger lock
to prevent accidental activation.
Use the trigger lock when the cleaner is not in
use, when it is being left unattended, or when
setting the product down to avoid accidental
operation.
1. Activate the trigger lock by pressing the
lock button located closest to the trigger on
the bottom of the grip.
2. Deactivate the trigger lock by pressing the
unlock button located further back on the
bottom of the grip to start operation again.
testing the machine for the first time.
1. Fully assemble the product and attach
attachments to the lance.
2. Connect water supply hose to product.
3. Turn water supply ON.
4. Make sure the on/off switch located at the
front of the machine is on “O” (off).
5. Insert the plug into a correct voltage power
outlet/socket.
6. Turn the on/off switch to “I” ( on ).
7. Deactivate the trigger lock by pressing the
unlock button.
8. Direct the nozzle away from yourself and
others.
9. Hold the trigger gun with both hands firmly.
10. Press the trigger, a water jet sprays out of
the nozzle.
11. Release the trigger to stop the spray.
12. Activate the trigger lock by pressing the
lock button to lock the trigger into its off
position.
13. Turn the on/off switch to “o” ( off ).
14. Turn water supply off.
General operation
• Before each use check the product, its
power cord, plug and accessories for
damage. Do not use if the product if
damaged or shows signs of wear.
• Double check that accessories are properly
attached.
• Always hold the product by the trigger gun
and lance, never by the nozzle.
• Check to make sure that the air vents
located on the back of the product are
unobstructed and clear. Clean them if
necessary with a soft brush and or remove
large blockages. Blocked air vents can
cause overheating and damage to the
product.
operation
1. Assemble the machine as described in
manual and switch it on.
2. Hold the trigger gun with both hands.
3. Direct the nozzle of your chosen attachment
away from yourself and others towards the
surface to be cleaned.
4. Press the trigger and direct the water jet at
the selected object to be washed.
5. Hold the lance the appropriate distance
away from the surface being cleaned
to avoid damaging it. If working on a
delicate surface a further away distance is
advised (see below for suggested cleaning
methods).
6. Release the trigger to stop the water jet.
cleaning vertical walls
1. For best results first dissolve dirt by
applying a detergent mixed with water to
the surface while the surface is still dry.
2. Allow the detergent to soak into the surface
for 1-3 minutes but do not let the detergent
dry.
3. Start from the bottom of the wall using
the high pressure rotor (turbo) nozzle at a
minimum distance of 30cm and work in an
upward direction. Do not let the rinse water
flow into unwashed areas.
4. If working on a large section of wall divide
the wall into sections to be cleaned.
5. On some walls high pressure cleaning
