Worx WG380, Руководство пользователя

Страница: 16 / 20

Cordless chain saw EN
16
clockwise direction, then retighten the
chain tensioning knob (8) to properly reset
the chain tension by repeating Steps 1-4
listed above.
LUBRICATION
IMPORTANT: The chain saw is not
filled with oil. It is essential to fill
with oil before use. Never operate the
chain saw without chain oil or at an
empty oil tank level, as this will result in
extensive damage to the product.
NOTE: Chain life and cutting capacity
depend on optimum lubrication.
Therefore, the chain is automatically
oiled during operation.
FILLING OIL TANK:
WARNING: Removing the battery
pack before filling the oil tank.
1. Set chain saw on any suitable surface with
oil filler cap (3) facing upward.
2. Clean area around the oil filler cap with
cloth and unscrew the cap by turning it
counter clockwise.
3. Add bar and chain oil until tank is full.
4. Avoid dirt or debris entering oil tank, refit
oil filler cap (3) and tighten by turning
clockwise until hand tight.
IMPORTANT: To allow venting
of the oil tank, small breather
channels are provided between the oil
filler cap and the strainer, to prevent
leakage, and ensure machine is left in
a horizontal position (oil filler cap (6)
uppermost) when not in use.
It is important to use only the
recommended standard bar and chain oil
(Grade: ISO VG32) to avoid damage to
the chain saw. This can be found at the
location where you purchased this saw
or your local hardware store. Never use
recycled/old oil. Use of non approved oil
will void the warranty.
Do not swallow. If swallowed, call a
physician immediately. Keep out of reach
of children. Store away from heat or
open flame.
CHECKING THE AUTOMATIC OILER
Proper functioning of the automatic oiler
can be checked by running the chain saw
and pointing the tip of the guide chain bar
(6) towards a piece of cardboard or paper
on the ground. If an increasing oil pattern
develops on the cardboard, the automatic
oiler is operating fine. If there is no oil pattern,
despite a full oil reservoir, contact WORX
customer service agent or WORX approved
service agent.
CAUTION: Do not touch the ground
with the chain. Ensure safety
clearance of 12”.
OPERATION
1. BEFORE USING YOUR CORDLESS
TOOL
WARNING!
The charger and battery
pack are specially designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard will
occur.
NOTE:
Your battery pack is UNCHARGED and
you must charge once before use.
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
2. CHARGING YOUR BATTERY PACK
The Li-ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
3. TO REMOVE OR INSTALL BATTERY
PACK (See Fig.F&G)
Depress the battery pack release button to
remove the battery pack from your tool.
after recharging, insert the battery pack into
the battery port. A simple push and slight
pressure will be sufficient until a click is heard.
Check to see if the battery is fully secured.
NOTE: When removing the battery pack,
hold it firmly to avoid dropping and injury.