Worx WA4300, Руководство пользователя

Страница: 6 / 12

Cordless Pruning Saw EN
6
WARNING: This product can expose you
to chemicals including lead and Di(2-
ethylhexyl)phthalate (DEHP) which are known
to the State of California to cause cancer and
birth defects or other reproductive harm. For
more information go to www.P65Warnings.
ca.gov.
SAFETY INSTRUCTIONS
WARNING Read and understand all
instructions. Failure to follow all instructions
listed below may result in serious personal injury.
1. When using the extension pole to cut the
branches on a tree, make sure to keep a firm
footing and balance. Do not stand in a position
where the branch may land after being cut.
2. When using this machine with the extension pole,
make sure to insert the battery pack to the pole
firstly.
COMPONENT LIST
1. LOCK-OUT BUTTON ON EXTENSION POLE
HANDLE
2. EXTENSION POLE HANDLE
3. ON/OFF SWITCH ON EXTENSION POLE
HANDLE
4. LOCKING KNOB
5. EXTENSION POLE RELEASE BUTTON
6. CLAMPING LEVER
TECHNICAL DATA
Machine length 63.0 inch (1.6 m)
Extension pole length 49.2 inch (125 cm)
Extension pole weight 2.4 lbs (1.1 kg)
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction
book carefully as well as the instruction book of
Pruning Saw WG324.
This extension pole is designed for use with Worx
Pruning Saw WG324 series.
ASSEMBLY
WARNING: Before attaching the extension
pole,make sure that the battery pack has
been removed.
(1) ASSEMBLING THE EXTENSION POLE
Align and insert the handle of extension pole into the
shaft. Rotate the Locking Knob clockwise to lock.
(See Fig. A1, A2)
NOTE: Make sure that the shaft is firmly locked in
place.
(2) ASSEMBLING THE EXTENSION POLE TO THE
MACHINE (See Fig. B1, B2)
Step 1: Align and insert the extension pole into the
saw.
Step 2: Hang the buckle on the hook of the saw. Press
the Clamping Lever to tighten the extension pole to
the machine.
NOTE: Make sure the extension pole is locked into
position securely before operation.
(3) REMOVING THE EXTENSION POLE (See Fig C)
Loosen the Clamping Lever to release the buckle.
Press the Extension Pole Release Button to
disconnect the extension pole with the saw.
WARNING! When using this machine with
the Extension Pole, make sure that the
battery pack has been removed.
WARNING! ELECTROCUTION HAZARD
Never use the pruning saw or extension
pole in an area with overhead power lines or
where the branch being cut can come into
contact with overhead power lines.
CUTTING WITH EXTENSION POLE
1. Attached the pole as described in “Assembly”.
2. Install the battery pack into the machine.
NOTE: Your battery pack maybe UNCHARGED and
you must charge it before usage. Depress the
battery pack release button to remove the battery
pack from your tool (See Fig. D1). After recharging,
insert the battery pack into the battery port. A
simple push and slight pressure will be sufficient
until a click is heard (See Fig. D2). Check to see if
the battery is fully secured.
NOTE: When removing the battery pack, hold it
firmly to avoid dropping and injury.
3. Before cutting a high branch, consider all the
same points detailed in the previous section
“Trimming Branches” but pay particular attention
to the likely path of the falling branch.
WARNING: Do not stand directly below a
branch being cut. Keep bystanders far
away. Do not stand on a ladder or other type
of unstable support while using the tool. Do