Worx LANDROID L WG795E, Руководство по установке

Страница: 14 / 132

14
EN
Open the keypad window
by pressing the ACCESS
button on the top of your
Landroid
®
L.
Press and hold down the
Power ON/OFF key
until the Landroid
®
L turns on.
Press the key and close
the keypad window: your
Landroid
®
L will now find its
way to the charging base.
Watch the Landroid
®
L as it
returns to the charging base
and modify the positioning
of the boundary wire if
necessary. When the
Landroid
®
L successfully
returns to the charging base,
this means the installation has
been successfully completed!
Now your Landroid
®
L will start
to fully charge.
2
• If your Landroid
®
L is
outside its territory, it
will not move and the
display will indicate
”
out of cutting area ”
error. Just move it inside
its territory and repeat
step 2.
• If your Landroid
®
L is
inside its territory but
the display says “
out
of cutting area ”, and the
LED is on, it means you
clamped the boundary
wire ends incorrectly.
Just reverse them.
• Your Landroid
®
L should
always remain switched
on. If you ever need to
turn it off, then make sure
you place it within its
boundary area before you
switching it back on again.
• Should your Landroid
®
L
stop operating
unexpectedly, just press
the ACCESS button, open
its keypad window, press
its ON/OFF key to ON,
correct the problems,
press
0 button, close its keypad
window.
NotE: If your Landroid
®
L is in the charging base during a time you have programmed it to mow, then simply press the
ACCESS button and close keypad window to send it back to mowing.
NotE: Please refer to the Programming and troubleshooting Guide for more information.
Warning