Worx H3 WX382, Оригинальное руководство пользователя

Страница: 9 / 120

Cordless rotary hammer EN
9 8
SYMBOLS OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for hammer drilling
in concrete, brick and stone. It is also suitable
for drilling without impact in wood, metal,
ceramic and plastic. Machines with electronic
control and right/left rotation are also suitable
for screwdriving.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY PACK
The battery pack charger supplied is matched to
the Li-Ion battery installed in the machine. Do
not use another battery charger.
The Li-Ion battery pack is protected against
deep discharging. When the battery pack is
empty, the machine is switched off by means of
a protective circuit: The chuck no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery pack to
cool down before recharging.
B) TO REMOVE OR INSTALL BATTERY
PACK (See Fig. A)
Depress the battery pack release button to
release and slide the battery pack out from
your tool. After recharge, slide it back into your
tool. A simple push and slight pressure will be
sufficient.
OPERATION
1. INSERTING AND REMOVING DRILL
BITS & ADAPTORS (11, 13) IN THE SDS
CHUCK
Take care that the dust protection cap
(1) is not damaged when changing tools.
— INSERTING (See Fig. B1, B2)
Clean and lightly oil the bit before inserting.
Insert the dust-free bit into the bit holder with
a twisting motion until it latches.
The bit locks itself. Check the locking by
pulling on the tool.
— REMOVING (See Fig. B3)
Retract back the bit holder locking sleeve (2)
and pull out the bit.
To reduce the risk of injury, user
must read instruction manual
Warning
Wear eye protection
Wear ear protection
Wear dust mask
Do not expose to rain or water
Do not burn
Do not dispose of batteries. Return
exhausted batteries to your local
collection or recycling point
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your
local authorities or retailer for
recycling advice.
xINR18/65-y: Cylindrical lithium
Ion battery cells with max diameter
of 18mm and max height of
65mm; “x” represents a number
cells serial connected, blank if 1;
“-y” represents a number of cells
paralleled connected, blank if 1.
Li-Ion