8
Symbols
Read the manual
Double insulation
Warning
Wear eye protection
Wear dust mask
Wear ear protection
WEEE marking
1
2
3
4
Operating instructions
Note:
Before using the tool, read the instruction book carefully.
ON/OFF SWITCH
To start your sander, depress the protective cover over the switch at
the position marked“I”.To stop your sander, depress the protective
cover at the position marked “0”.
HAND GRIP AREA
You can operate your sander with one hand (see A).
CHANGING THE SANDING PAPER
To remove the sandpaper, lift up the clamp lever (4) and move away
from the lever lock (5) (see B). The sandpaper clamp (3) is now loose.
Repeat with the other clamp on the opposite side of your sander.
To fit new sandpaper, insert approximately 5mm of one end of the
sandpaper under the sandpaper clamp (3) until the paper contacts
the housing wall (see B). Lift up the clamp lever (4) and move it to the
lever lock position.
Press the sandpaper around the base-plate shape as tight as possible
and fix the end under the other sandpaper clamp (3). Check the
sandpaper is square to the base-plate and remove and refit again.
if not correct, remove and refit it again.
Always, ensure the sandpaper is tight over the base-plate and
secured underneath both locked clamps (3). This will ensure safe and
efficient sanding performance.
CHANGING HOOK & LOOP SANDING PAPER
The sanding paper and baseplate are provided with a hook and loop
