Worx Professional WU326P, Руководство пользователя

Страница: 9 / 16

9
TROUBLE SHOOTING
The following table gives checks and actions that you can perform if your machine does not operate correctly.
If these do not identify/solve the problem, contact WORX Customer Service.
I would add a comment here to again recommend that you apply grease to the shank of every drill bit used.
Symptom Possible Cause Remedy
Machine fails to operate
No power supply to machine. Use another socket.
The brushes are worn out. Have a qualified person to check them,
and replace them if necessary.
The power and hammer
efficiency of the machine
is low.
Machine may be cold. Warm up the machine for 1-2 minutes
until it reaches a proper working
temperature.
The connecting rod is broken (lacking of
grease oil or the gearbox is dirty).
Have a qualified person to replace it if
necessary and add grease oil.
There is no enough grease oil in the
gearbox.
Have a qualified person to add some
grease oil (about 2 or 3 bottle caps).
Your bit does not slide freely in the
chuck.
Clean the dust and debris inside the
chuck; Grease the shank of the bit if
necessary.
Your drill bit will not fit into
the chuck easily
The chuck is dirty with dust and debris. Clean the dust and debris from inside
the chuck.
The shank of the bit is damaged or
distorted.
Change a new bit.
A drill bit has broken and the shank has
remained in the chuck.
Remove the chuck, and take out the
bit as shown in Fig. B, then clean the
chuck inside.
You cannot remove your drill
bit from the chuck
The shank of the bit is damaged or
distorted;
The chuck is dirty with dust and debris.
Remove the chuck, and take out the
bit as shown in Fig. B, then clean the
chuck inside.