Worx Professional WU282PT, Руководство пользователя

Страница: 7 / 76

7
1
2
3
Operating instructions
Note:
Before using the tool, read the instruction book
carefully.
Intended use:
This tool is intended for the fastening and loosening of bolts, nuts and
various threaded fasteners. This tool is not intended for use as a drill.
COLLET LOCKING SLEEVE
Pull the collet locking sleeve forward. Fully insert the desired bit into
the chuck and release the collet locking sleeve. The collet accepts
only standard 1/4” hexagonal shank accessories with power groove.
Do not use this tool as a drill. Tools equipped with shutoff clutches
are not designed for drilling applications. The clutch can shut off
automatically and without warning. Attempting to restart drilling after
shut-off has been reached can cause the tool to twist out of your
hand until the clutch again reaches shut-off. Do not attempt to insert
quick change type drill bits into this chuck.
REMOVING A BIT HOLDER, SOCKET OR SCREWDRIVER BIT
Pull the collet locking sleeve forward. Take the tool out of the chuck
and release the collet locking sleeve (Fig. A).
FORWARD, REVERSE ROTATION AND LOCK CONTROL
Your tool is equipped with a forward, reverse rotation and lock
control located above the on/off switch. It was designed for changing
rotation of the chuck and for locking the on/off switch in the center
Always charge the battery pack between temperatures 0
o
C
to 30
o
C
1hour charging time
WEEE marking