Worx Professional Versacut WU420, Руководство пользователя

Страница: 13 / 58

13
work piece, based on the blade depth that was selected.
Always practice in a scrap work piece to become familiar with this
cutting operation. The selected depth of cut is now set. When the
saw’s blade is manually lowered, the blade will be below the base at
the selected depth.
USING THE LASER
The laser is used as a cutting guide and should form a red line on
the material surface that is exactly aligned with the blade alignment
indicator (12).
Press down the laser on/off switch (5) to turn on the laser.
Press down the laser on/off switch again to turn off the laser. (See
Fig. I)
Note:
Clean the laser generator periodically.
Warning: Never stare directly into the laser beam and never point
the beam at anybody. The laser beam energy is extremely harmful to
human eyes.
Warning:
When not in use, always turn the laser off to save the
battery capacity.
To replace laser batteries (See Fig. J1-J6)
The saw comes with laser batteries well assembled. When battery
capacity runs out, replace batteries as follows:
Use 1.5V batteries model LR44, typical to calculators, cameras and
similar small electronics.
Move the battery storage cover (16) in the direction the arrow (on the
cover) points. Then lift the battery storage cover (See Fig. J1, J2).
You can see one end of a cord. To remove the batteries, just slowly
pull the end of the cord. The two batteries will be taken out along
with the cord (See Fig. J3).
To fit new batteries, adjust the position of the cord and insert two
batteries in place. Make sure two batteries are pressed on the cord
(See Fig. J4, J5).
Restore the cover (See Fig. J6).
Note:
Pay attention that “+/-” of the batteries are the same as the
illustration on the machine.
CUTTING GUIDE (See Fig. K)
The blade alignment indicator (12) in the front of the base plate is
used as a cutting guide. Always guide it along the cutting mark made
on the workpiece for accurate cutting.
Note: It is best to carry out a trial cut.
Function
MAKING CROSS CUTS AND RIP CUTS (See Fig. L, M)
Warning:
To avoid sudden kick-back, never start a stationary
blade while it is in contact with the work piece.
Always start the saw and allow it to reach full speed before
commencing to plunge.
The blade teeth are exposed during this operation so proceed with
extreme caution.
a).
ALWAYS
use your saw with your hands positioned correctly.
Warning: Always maintain proper control of the saw to make
sawing safer and easier. Loss of control of the saw could cause an
accident resulting in possible serious injury.
b). When making cross or rip cuts, align your line of cut with the
center of the “V” (blade alignment indicator), located on the front of
the saw’s base (See Fig. L).
c). Since the thickness of blades vary, make a trial cut in scrap
3
4
1