Worx Professional Sonicrafter WU675, Оригинальное руководство пользователя

Страница: 10 / 130

10
MOuNTING THe suCTION deVICe (see Fig. d1, d2)
When vacuuming, mount the suction device as shown in D1-D2.
Note: using the sanding pad perforated. You can only do the
vacuuming after fitting the dust collector.
sANdING
Typical application: wood, metal; small areas, especially corners,
edges and places difficult to access.
Select high oscillation frequency.
Sand with a constant movement and light pressure.
Heavy pressure does not increase the removal – the sanding sheet
merely wears faster.
sAWING WITH THe seGMeNT sAW BLAde
Typical application: wood, plastics, sheet metal.
Select high oscillation frequency.
The saw blade lasts longer if the wear is distributed evenly. To ensure
an even distribution, loosen the saw blade, rotate it and retighten
firmly.
sAWING WITH THe uNIVeRsAL eNd CuT sAW BLAde (see Fig. e)
Warning: The sawing teeth are very sharp. do not touch
during mounting and application.
The workpiece must be inserted firmly or clamped tightly before it is
cut.
Typical application: wood, metal (e. g. nails),plaster board and soft
plastics.
When plunging and sawing use a slight pendulum motion, to allow
sufficient chip removal.
6
7
8
9
sCRAPING
Typical application: Scraping off old varnish or adhesives, removing
glued carpeting, e. g. on stairs or other small to medium-sized
surfaces.
Select medium / high oscillation frequency (for variable speed
models).
Led LIGHT (1)
To turn on the light simply press the on/off switch. When you release
the on/off switch, the light will be off.
LED lighting increases visibility-great for dark or enclosed area. LED is
also a battery capacity indicator. It will flash when power gets low.
TeMPeRATuRe dePeNdeNT OVeRLOAd PROTeCTION
When using as intended for, the power tool cannot be subject
to overload. When the load is too high or the allowable battery
temperature of 75°C is exceeded, the electronic control switches off
the power tool until the temperature is in the optimum temperature
range again.
PROTeCTION AGAINsT deeP dIsCHARGING
The Li-Ion battery is protected against deep discharging by the
“Discharging Protection System”. When the battery is empty, the
machine is switched off by means of a protective circuit: The inserted
tool no longer rotates.
dIsPOsAL OF AN eXHAusTed BATTeRY PACK
To preserve natural resources, please recycle or dispose of
the battery pack properly. This battery pack contains Lithium
batteries. Consult your local waste authority for information
10
11
12
13
14