Worx Nitro WG185E Series, Инструкция по безопасности и эксплуатации

Страница: 12 / 16

12
Cordless Grass Trimmer
WG185E WG185E.X
Checking the battery charge
condition
NOTE: Fig. D3 only applies for
the battery pack with battery
indicator light.
See Fig. D3
Charging the battery pack
NOTE:
• The batteries are shipped
uncharged. Each battery must be
JYPP]GLEVKIHFIJSVIXLIƼVWXYWI
• Always fully charge the two
batteries at same time. More
details can be found in charger’s
manual.
See Fig. D4
Battery power indicator on the
machine
See details in BATTERY STATUS
section
See Fig. D5
Operation
To start
WARNING! The cutting
head continues to rotate
after the trimmer has been
switched off; wait until it has
completely stopped then lay down
the tool.
4VIWWXLIPSGOSJJFYXXSRƼVWX
then press the switch trigger to
start the machine.
See Fig. E
ECO Speed
For longer run time, press the ECO
button and switch trigger, then
your machine will operate at a low
speed.
See Fig. F
Trimming See Fig. G
Bump feed See Fig. H
Assembling and removing the
trimmer head
Insert the hex key into the hole
and rotate the trimmer head
until it stops in a locked position.
Then, rotate counterclockwise
to remove it, and clockwise to
assemble it.
See Fig. I
Winding the trimmer line
NOTE: The spool must be wound
while installed in the trimmer
LIEH)\XIVREPP]VIƼPPIHWTSSPW
inevitably leads to problems.
See Fig. J1,J2
BATTERY STATUS (See Fig. D5)
Before starting or after use, press the button beside
the power indicator light on the machine to check
the battery capacity. During operation, the battery
capacity will be indicated automatically by the battery
power indicator.
The indicator constantly senses and displays the
battery condition as follows.
For the machine with 2 battery packs with different
power, the power indicator light displays the battery
condition with the lower one of the two batteries.
Battery power
indicator status
Battery condition
Five green lights (
) are
illuminated.
The two batteries are in a highly
charged condition.
Two, three or four
green lights are
illuminated.
The two batteries have a
remaining charge. The more
lights are illuminated, the more
battery capacity.
Only one green light
( ) is
illuminated.
At least one battery is almost
depleted and needs to be
charged.
No light is
illuminated.
At least one battery is not fully
installed or battery may be
defective.
Only one light is
ƽEWLMRKX[MGITIV
cycle.
At least one battery is over
discharged (please refer to
the battery charge condition),
please recharge the two
batteries at once before use
again or storage.
Only one light is
ƽEWLMRKXLVIIXMQIW
per cycle.
At least one battery is hot, wait
for them cool down before start
again.
Only one light is
ƽEWLMRKJSYVXMQIW
per cycle.
The machine is over load.
Raise the cutting height or push
slowly.
OPERATION
INSTRUCTIONS
WARNING! The charger and battery pack are
specially designed to work together so do not
attempt to use any other devices. Never insert or
allow metallic objects into your charger or battery
pack connections because of an electrical failure and
hazard will occur.
1. Bump-line feed system (See Fig. H)
The trimmer is equipped with a bump-line system.
Just bump the trimmer head while the machine is
running, new line will feed out.
2. Winding the trimmer line (WA0201)(See Fig.
J1,J2)
Insert the replacement line through the eyelet and
feed it through the other side. Ensure both ends of