Worx Nitro WG185E Series, Инструкция по безопасности и эксплуатации

Страница: 11 / 16

11
WG185E WG185E.X
Cordless Grass Trimmer
changes between these models.
***Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
SUGGESTED BATTERIES
AND CHARGERS
Category Model Capacity
20 V Battery WA3014 4.0 Ah
20 V Charger WA3883 4.0 A
We recommend that you purchase your
accessories listed in the above list from the same
store that sold you the lawn trimmer. Refer to the
accessory packaging for further details. Store
personnel can assist you and offer advice.
NOISE INFORMATION
A weighted sound pressure L
pA
= 78.7dB(A)
K
pA
3.0 dB(A)
A weighted sound power L
wA
= 91.97 dB(A)
K
wA
1.44dB(A)
Wear ear protection.
VIBRATION INFORMATION
Typical weighted vibration a
h
<1.5 m/s 2
Uncertainty K = 1.5 m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the
tool is used dependant on the following examples
and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
NSF8LMWQE]WMKRMƼGERXP]VIHYGIXLII\TSWYVIPIZIP
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
4.ASSEMBLY & OPERATION
Action Figure
Assembly
Assembling the Auxiliary Handle
See Fig.
A1,A2,A3
Assembling the pole See Fig. B
Assembling the Safety Guard
Insert the metal bracket into the
slot on the safety guard, then
secure the guard in place using
the screw and hex key.
See Fig. C
Installing and Removing the
Battery Pack
NOTE:
• This machine will only run when
2 batteries are installed. It is
recommended to use the same
two batteries and charge the two
batteries at the same time.
• When two batteries are used
with different amp hours or
charge level, the machine will
run to the lowest common
denominator.
• It is recommended that using
4.0Ah or above battery pack for
better performance and longer
run time.
See Fig. D1, D2