Worldlawn WYZ 52, Руководство оператора

Страница: 24 / 44

19
“START” .Insert the key into switch and rotate clockwise to the “ON” position.
Rotate clockwise to the next position to engage the starter (key must be held against spring pressure in this
position)
Brake must be engaged, motion control levers out (neutral lock position) and PTO switch “OFF” to
start engine.
(It is not necessary for the operator to be in the seat to start the engine)
4.1.9 Hour Meter: Locate on the right fuel tank.
The hour meter is connected to a pressure switch installed in the engine block and it records the number of
hours that the engine has run .If ignition switch is left on without engine running, hour meter will not run.
NOTE: This switch is not a low oil sensor and will not alert the operator if the engine oil is low.
4.1.10 Fuel Shut-Off Valve: Locate directly below center of console.
The fuel shut-off valve is used to shut off the fuel when the machine will not be used for a few days, during
transport to and from the jobsite, and when parked inside a building.
a) ROTATE The fuel shut-off valve counter-clockwise is to open the valve.
b) ROTATE The fuel shut-off valve clockwise is to close the valve.
c) The fuel shut-off valve on both side keep open, the fuel can flow through both tanks without
restriction.
4.1.11. Drive Wheel Release Valves:
Release valves are used to release the hydrostatic drive system to allow the machine to be pushed without
the engine running. Unhook seat latch and tilt seat up to gain access to pumps.
Hydra-Gear : Located on the right front corner of the hydrostatic pumps .
With a 5/8 wrench, turn both valves one turn counter-clockwise to release drive system.
Turn clockwise to reset system.
DO NOT over tighten. DO NOT tow machine.
White: Located on the right front corner of the hydrostatic pumps .
With a 11/16wrench, turn counter-clockwise to loosen the nuts, then With a 5/16 wrench,. turn
the valve counter-clockwise to release drive system.
Turn clockwise to reset system.
DO NOT over tighten. DO NOT tow machine.
4.2 PRE-START
4.2.1 Fill fuel tanks .For best results use only clean, fresh regular grade unleaded gasoline with an octane rating
of 87 or higher. Regular grade leaded gasoline may also be used; however, combustion chamber and
cylinder head will require more frequent service; see Engine Owner’s Manual,
DO NOT
add engine oil to
gasoline.
Do Not
overfill fuel tank.
4.2.2 Make sure you understand the controls, their locations, their functions, and their safety requirements.
4.2.3 Refer to Maintenance. Section 5, and perform all necessary inspection and maintenance steps.
4.2.4 Check the tire inflation:
wheels Inflation
Drive wheels
20psi(138kPa)
Caster wheels 40psi(276kPa)