Worldlawn WYZ 52, Руководство оператора

Страница: 18 / 44

13
unit to fall, which could cause injury.
HOW TO AVOID THE HAZARD
· DO NOT rely solely on the mechanical or hydraulic jacks for support. Use adequate jack stands
or equivalent support.
3.2.3 Remove the drive wheels from both sides of the unit.
3.2.4 Install the two lower roll bar tubes.
a) Locate the left and right lower roll bar tubes.
b) Align lower roll bar tubes along wheel motor channels as show in Figure 2.
c) LOOSELY install lower roll bar hardware.
FIG 2. Lower Roll Bar Installation
3.2.5 Install the upper u-shaped section of the roll bar. (As show in Figure 3)
a) Locate the latch pin assemblies(pin and hairpin connected with a lanyard)
b) Locate the upper u-shaped section of the roll bar. Install the upper roller section using the bolts and lock
nuts. Do not over tighten .Make sure upper roll bar can pivot freely.
c) Torque all lower roll bar hardware attached to the machine frame to 41-47 N-m.
d) Assembly the diver wheels on both sides, Torque all the nuts attached to the drive wheel to 128N.m.