World Cat 280CC-X, Руководство пользователя

Страница: 52 / 66

51
10.1.6 Livewell System (Optional with Fishing Package)
The 20 gallon livewell system is supplied by a dual purpose livewell pump. The pump is located in the port
mechanical room. The wiring is secured to the pump using a tie-strap, and must be disconnected prior to
removing the pump.
The livewell pump draws water through the strainer mounted on the inboard side of the port sponson. A
seacock is installed between the pickup and the pump to allow you to seal the system between use, or in
the event of a plumbing failure.
To operate the livewell, first verify that the seacock is open, then install the supplied drain plug in the
bottom of the livewell located in the aft portion of the port back-to-back seat. When you have completed
these steps, turn the pump on with the dedicated livewell switch located on the port wall beside the
back-to-back seat. Water will fill the tank until it is level with the overflow drain in the top corner of the
livewell tub which allows the excess water to drain overboard through the port hullside. To clear bait
residue that has collected in the bottom of the tub, temporarily pull out the drain plug to allow waste to
escape. Put the plug back into position to resume normal operation. When you have finished using the
livewell turn the pump off and discard any left-over bait. Pull the plug out of the bottom drain and allow
all the remaining water to exit the bottom of the tub. To view the layout of the livewell system see the
drawing in section 10.4.6.
NOTICE
While underway, leaving your livewell seacock open could result in inadvertently filling your
livewell. To prevent this, close the seacock when the pump is not in operation.
NOTICE
Operating the engines in reverse can cause excessive ventilation near the livewell intake, causing
the pump to airlock. To prevent this, turn the pumps “OFF” prior to any continuous or high speed
reverse operation. If your pump does becomes air locked, turn the pump “OFF” for 15 to 30
seconds to correct the problem.
10.1.7 Raw Water System
The raw water pump and strainer are mounted on the rigging wall in the port mechanical room located
in the port aft cockpit of the boat. The strainer is connected to a high-speed pickup through the seacock
located on the inboard side of the port sponson. The seacock must be in the open position for the system
to work. Similar to the freshwater pump, the raw water system is controlled by a built-in pressure switch
set at 60psi. The pump will cycle on and off as needed to maintain this pressure. Most owners leave the
pump in the on position throughout the day and use the system when necessary. On the 280DC-X the raw
water pump is switched on by a push button mechanical switch located on the dash area. The 280DC-X
has two raw water outlets, one is located on the port wall beside the back-to-back seat and the other is a
hose coil located inside the port anchor locker to allow easy rinsing of the anchor and chain, as well as the
bow of the vessel. To view the layout of the raw water system see the drawing in section 10.4.6.