World Cat 2011, Руководство пользователя, Страница: 62 / 109

2012 World Cat 290EC Owners Manual
10.3 O
PERATION OF
O
PTIONAL
E
QUIPMENT
10.3.1 Generator
The Fischer Panda™ generator is installed under the deck, and can be accessed using the hatch located in the floor on
the port side of the helm leaning post. For rigging information, review section 10.4.6 of this manual. Prior to using
the generator, review the manual provided by Fischer Panda™ which is included in your “Owner’s Portfolio”. Follow
these startup guidelines before each use of the generator:
1. Verify that the seacock located in the stbd aft bilge compartment is open.
2. Verify that the “Port Start” battery switch is “ON”.
3. Turn off the “Ship Power” breaker and all accessory breakers located on the AC Panel
4. Press the “ON” button on the generator control panel, located on the aft cabin wall, and wait for the unit to perform its
self-test. If an error message is displayed on the LCD screen, do not attempt to start the unit. Contact your dealer and
schedule a maintenance check.
5.
Use the start button on the control panel to crank the generator.
!
!
C
C
A
A
U
U
T
T
I
I
O
O
N
N
If the generator does not start within the first three attempts, turn the panel off and contact your dealer
prior to further use. Failure to do so, will result in significant damage to the generator
.
1. Once the generator is running, engage the “SHIP POWER” circuit breaker and verify that the “REVERSE
POLARITY” indicator is not lit. If it is not lit proceed to step 7, however, if the red LED indicator is lit, immediately
turn “OFF” the “SHIP POWER” breaker and shut down the generator. Notify your dealer regarding the issue and
have a trained electrician inspect your boat to determine if any damage has been sustained by the electrical system.
2.
You may now engage the AC accessory breakers.
! ! C C A A U U T T I I O O N N
For safety reasons, the seacock must be closed after the generator has been switched off. It should be re-
opened before starting the generator.
Routine maintenance should be performed on this unit using the guidelines established by Fischer Panda™. Failure to
comply with these guidelines will result in loss of warranty coverage and creates the potential for property damage or
personal injury.
10.3.2 Climate control unit
The heating/air conditioning unit is mounted under the dash. It can be accessed by removing the bulkheads located
between the cabin headliner and the galley and head countertops. The return air grill and control panel are located on
the galley bulkhead. Follow these startup guidelines before each use of the unit:
1. Verify that the seacock located in the port aft bilge compartment is open.
2. Using the guidelines provided, energize the AC panel using the generator of shore power connection and engage the
corresponding circuit breaker.
3. Using the control panel, energize the climate control unit and select the operating mode and desired temperature using
the selection tools. This will engage the raw water pump located in the port aft rigging compartment.
4. Once the unit is running, inspect for water flow through the system by checking the thru-hull located on the port
sponson (see Thru-Hull drawing section 11.4.9). If water is not flowing, shut down the unit immediately to prevent
damage. Then have your dealer inspect the system.
Similar to a residential system, the filter units must be replaced at regular intervals to ensure proper operation. Use the
Page 10-61