World Cat 2010 230SF, Руководство пользователя

Страница: 39 / 50

World Cat
5-4
DIGITAL CONTROL SYSTEM
Your 230 SF comes equipped with the digital control system discussed in Chapter 3 of this manual.
The switch pod is located on the console forward of the helm and binnacle. The control unit and accessory
fuse block are mounted inside the console and can be accessed using the lower inspection hatch on the par-
tition wall. The boat’s wiring harnesses are connected to the control unit and accessory fuse blocks by an
adapter harness. The wires are labeled at both ends of the harness to make it easier to identify circuits. Wir-
ing diagrams are provided on pages 9-10 to help you to trace circuits when needed.
BILGE PUMPS / FLOAT SWITCHES
Your 230 SF is equipped with two 1500 GPH bilge pumps. Each pump is connected to a float switch
which automatically triggers the pump when water comes to rest in the bilge. The float switches are con-
nected to the battery management panel through the hull harness and receive power from the fuses along
the top of the panel. These fuses are constantly energized and ensure the safety of your boat even when the
battery switches are in the “off” position. The pumps can be manually engaged using the switch pod
located on the console.
The bilge pumps are located behind the aft rigging compartment and can accessed through the inspec-
tion plates in the motorwell, forward of the engines. The wiring for these pumps is secured to the inboard
side of the centerline stringer which is visible from the inspection port.
Inspect the operation of your bilge pumps and their connections at least annually. To do so, activate the
pump by momentarily lifting the arm on the float switch, then check the operation using the switch pod.
When testing, do not allow the pumps to run dry for more than two to three seconds. Extended dry opera-
tion can result in damage to your pump. Keeping your bilge areas clean can also help extend the life of
your pump.
FRESHWATER SYSTEM
The freshwater pump and wiring are located in the console rigging space. The freshwater pump is con-
nected to the 8 gallon freshwater tank also located in the console. The tank is filled through a fitting located
on the port vertical wall of the console. Similar to residential well pumps, the freshwater pump pressurizes
the system to 45 psi. then shuts down until the pressure drops below that level. Most owners leave the
pump “on” throughout the day, and use the system when necessary. On the 230 SF, the freshwater pump
feeds the Hosecoil™,
(see operating instructions on page 6) , through the y-valve located on the starboard
side of the leanbar. To view the layout of the freshwater system see the drawing on page 13.