Operation
23
Adjusting the height
1. Hold the drilling table
12
in place with one hand.
2. With the other hand, loosen the rotary knob for setting the height
9
which fixes
the drilling table on the drill column
7
somewhat.
3. Position the drilling table at the desired height.
4. Tighten the rotary knob again.
Adjusting the incline
The drilling table
12
can be inclined at an angle of no more than 45° to either the left
or right. To set the incline you will need a 10 mm hex key (not included in the package
contents).
1. Using the 10 mm hex key, loosen the screw for setting the incline
11
(see
Fig. E
).
2. Turn the drilling table to the right or left.
You can determine the set angle with the scale for setting the incline
8
.
For exact adjustment, the drilling table is marked so you can set the exact number
of degrees.
3. Tighten the screw for setting the incline again.
Setting the drill depth
You can set the desired drill depth with the scale ring.
1. Switch the drill off (push the red off switch
O
31
) and pull the mains plug out of
the socket.
2. Loosen the clamp screw for setting the drill depth
18
which is used to fix the scale
in place.
3. Lower the chuck
13
with the fitted tool onto the workpiece.
4. Turn the scale forward to the stop point until the arrow mark for setting the drilling
depth
16
is pointing towards the zero line of the scale.
5. Turn the scale to the desired drill depth. If you would like to drill a hole with a
depth of 20 millimetres for example, turn the scale to “20”.
6. Tighten the clamp screw for setting the drill depth again.
7. Move the spindle back to the home position.
Switching on and setting the line laser
1. Open the battery compartment cover
30
, insert the batteries with correct polarity
and close the battery compartment cover again.
2. To switch then line laser
26
on, push the On/Off switch for the line laser
28
(see
Fig. C
).
