12
WGG-800
www.servotool.eu
0203-5142281
GB
1800-719901
IRL
AFTER SALES SUPPORT
WGG-800
www.servotool.eu
0203-5142281
GB
1800-719901
IRL
AFTER SALES SUPPORT
6 Months or 100 hrs
•
Clean fuel tap and fuel tank filter. Replace if necessary.
•
Check fittings and fasteners. Replace if necessary.
12 Months or 300 hrs
•
Contact a specialized service centre to check the valve clearance.
•
Check the fan of the cooling system for damage.
Spark plug inspection
Fig. 2
•
Disconnect the spark plug cap, and remove any dirt from around the spark plug
area.
•
Remove spark plug (10) with the plug spanner supplied.
•
Inspect the base of the spark plug. It should be a tan colour.
•
Measure the gap (distance contact point) with a suitable gauge. The gap should be
0,7 - 0,8 mm. Correct the gap, if necessary, by carefully bending the side electrode.
•
Replace the spark plug if the electrodes are worn, or if the insulator is cracked or
chipped.
•
Install the spark plug carefully, by hand, to avoid cross-threading.
•
Tighten the spark plug to the correct torque: 20 Nm.
•
Attach the spark plug cap.
Exhaust screen
•
Wait for exhaust to cool.
•
Exhaust screen may be blocked up with carbon deposits.
•
Undo the screw cap and remove the exhaust screen.
•
Clean the screen with a wire brush and refit.
•
Replace exhaust screen if damaged.
Air filter cleaning
•
Remove the air filter cover (9).
•
Remove filter element and wash thoroughly in solvent.
•
Pour a small amount of oil onto the filter element and gently squeeze out any
excess oil.
•
Replace the filter element and air filter cover.
•
Be sure the filter cover seals properly all around.
Do not run the engine without the air filter element in place.
Never place a wet filter (with solvent) on the machine.
PGM6003 Ma EN-IRL 1202-15.indd 12
2/15/12 9:35 AM
