Workzone M1Y-DU10-190, Оригинальная инструкция по эксплуатации

Страница: 20 / 28

External dust extraction (figures C, D)
• The elbow connector for external dust extraction (21) can be used with or without external
dust extraction.
• Direct the ejection outlet of the elbow connector (21) in such a way, depending on the sawing
job, that you or other persons cannot be injured by ejected chippings.
• Push the elbow connector for external dust extraction (21) firmly into the dust and chippings
outlet (12) and make sure that it is firmly seated.
• Connect the extraction hose (22) (not supplied) to the elbow connector (21) or directly to the
dust and chippings outlet (12).
• Connect the extraction hose to a vacuum cleaner. The vacuum cleaner must be suitable for
the material being sawn.
• Use a special vacuum system if you are extracting particularly hazardous, carcinogenic or dry
dusts.
Inserting/changing batteries (figure E)
• Open the battery compartment cover (4) by removing the screws next to the side handle (3)
(arrowed) with a cross-head screwdriver and remove the cover.
• Remove any flat batteries and dispose of these in a responsible way.
• Insert two new R03/LR03/AAA, 1.5 V batteries in the battery compartment. Pay attention to
correct polarity (+/-), as illustrated on the floor of the battery compartment.
• Replace the battery compartment lid and secure it with the two screws.
Adjusting the parallel guide stop (figure F)
• Slacken the wing nut for the parallel guide stop (7) on the soleplate (10) and push the parallel
guide stop (8) into the groove provided.
• Set the parallel guide stop to the desired distance and retighten the wing nut (7).
14
6
Setting up
M1Y-DU10-190 / 90704
After Sale support
0845 872 2740
GB
019022605 IRL
www.sumecservicecentre.co.uk