Operations
11
Assembly
Install the castors before using the trolley (see
fig. B
).
1. Place the trolley upside down.
2. Place the fixed castors
6
at the front end and the swivel castors
4
at the
rear end of the trolley. Line up the holes on the castors with those on the
trolley.
3. Insert the screws
7
through the holes from below and then attach the
nuts
8
to the screws.
4. Tighten all screws with the wrench
9
.
Operations
CAUTION!
Risk of crushing!
You could crush your fingers when setting up the trolley.
− Be very careful when you are opening or closing the
trolley.
NOTICE!
Risk of damage!
If you do not use the trolley properly, you could damage it.
− Pull the handle far enough so that it locks into the end
position before use. If not locked, the handle may retract
when the trolley is pushed forward.
Opening the trolley
To open the trolley:
1. Pull the rear guard
2
and handle
1
assembly upward until it locks (see
step 1 in
fig. C
).
2. Press the rear guard downward and pull the handle upward until it latches
(see step 2 in
fig. C
).
The trolley is now ready for use.
Содержание AET14
Страница 3: ...3 A 1 2 4 5 6 7 8 9 3...
Страница 4: ...4 B C 4 6 D 1 2 5...
Страница 5: ...5 E F 1 2 3 1 2 3 10...