KCM1420
ERGONOMIC KNEE CHAIR
ASSEMBLY INSTRUCTIONS
© Office Star Products May 2009
PART
QTY
1. Casters . . . . . . . . . . . . . . . . . . . . . 4
2. Seat Support . . . . . . . . . . . . . . . . . 1
3. Knee Support . . . . . . . . . . . . . . . . . 1
4. Short Screws . . . . . . . . . . . . . . . . . 3
5. Long Pivot Pin . . . . . . . . . . . . . . . . 1
6. Mid Pivot Pin . . . . . . . . . . . . . . . . . 1
7. Small Pivot Pin . . . . . . . . . . . . . . . 1
8. Height Adjuster . . . . . . . . . . . . . . . 1
9. Seat Cushion . . . . . . . . . . . . . . . . . 1
10. Knee Cushion . . . . . . . . . . . . . . . 2
11. Flat Washers . . . . . . . . . . . . . . . . 7
12. Long Screws . . . . . . . . . . . . . . . . 7
13. Allen Wrench (not shown) . . . . . . 1
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1
Insert four Casters (1) into Seat Support (2) and Knee Support (3), push hard until you feel or hear the Caster (1) snap into place.
STEP 2
Insert Seat Support (2) through center of Knee Support (3). Align pivot pin holes of Seat Support (2) with pivot pin holes of Knee Support (3) and slip
Long Pivot Pin (5) through holes and secure using Short Screw (4).
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (13).
STEP 3
Insert Height Adjuster (8) into Seat Support (2) and align holes and secure using Mid Pivot Pin (6) and Short Screw (4). Align holes of Height Adjuster (8) with
Knee Support (3) and secure using Mid Pivot Pin (6) and Short Screw (4).
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (13).
STEP 4
Attach Seat Cushion (9) to Seat Support (2) with arrows pointing forward. Secure using three Long Screws (12) and three Flat Washers (11).
STEP 5
Attach Knee Cushions (10) to Knee Support (3), secure using two Long Screws (12) and two Flat Washers (11) for each Knee Cushion (10).
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
6
5
2
1
7
3
4
4
8
4
11
12
10
9
10
11
12
