Workrite Ergonomics | 800.959.9675 www.workriteergo.com
7
Workrite Sierra HXL™ 2-Leg Crank Workcenters - Assembly Instructions
Half the leg width
Half the leg depth
Center of leg
9
10
11
a
b
Attach Front Crank Drive (for Top-Crank proceed to Step 11)
a
a
b
E
L
The front crank drive and handle can be installed on the
right or left side as required. The steps shown illustrate a
right side handle installation (change to opposite side for left
installation).
Place the Crank Handle Assembly (E) into the Right Leg as
shown.
Attach with #12 × ½" Self Tapping Phillips Pan Head Screw
(L) and tighten firmly.
Attach the Handle Mount
For Workrite Tabletops:
Locate the pre-drill holes for the handle mount. Install
4 #12 × ¾" Pan Head Wood Screws (M) and tighten firmly.
Go to Step 12.
For Other Tabletops:
Measure 3 ½" back from the front of top to the front of the handle mount.
Be sure the handle is not at an angle. Drill 1/8" × ¾" deep
pilot holes. Take care not to drill through top! Install 4
#12 × ¾" Pan Head Wood Screws (?) and tighten firmly. Go
to Step 12.
3½"
a
M
a
b
Base-Only Top-Crank Models: Loosely Secure Table Base to Tabletop
Position the leg assembly on the face-down table top. Center the assembly on the table so that
neither of the side legs overlap the edge. Measure carefully to ensure that your table will be
positioned correctly as detailed below before drilling.
Mark ¾" hole for crank handle: Trace around outside of leg bracket before removing leg
assembly. Measure from front left corner of leg bracket as shown, then mark hole placement. The
hole should be directly under the center of the leg.
Use the ⅛" drill bit to drill from the bottom of the worksurface completely through the
worksurface as step one in drilling. DO NOT USE ¾" bit. Drill from bottom to avoid damaging
top surface.
a
b
1⅜"
1⅞"
Trace
Trace
1⅜"
1⅞"
