4 of 4
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Cable Management
Upper arm: Insert cables into the recessed area under the
upper arm by pushing the cables through the clips.
Lower arm: Remove the cover by sliding it up, then off. Secure
cables with Hook & Loop strips. Slide cover down to secure.
Desk Base: Run the cable from lower arm to the back of
the base. Put cables into the cable clip.
Note: Leave sufficient slack in the cables
to allow free movement of arm.
#1500246 Rev F
Parts & Support
C-Clamp & Grommet Base ....................................................
CONF-BSE-CCG-S
Tw Pc C-Clamp & Grommet Base ..........................................
CONF-BSE-TPCCG-S
Tool Bar & Slatwall Base .......................................................
CONF-BSE-TSB-S
Wall Plate Base ......................................................................
CONF-BSE-WP-S
Dual Arm Adaptor ..................................................................
CONF-ADPT-DA-S
Knoll
®
Antenna
®
Adaptor .....................................................
CONF-ADPT-KA-S
14” Pole Base with C-Clamp & Grommet .............................
CONF-PB-14CCG-S
28” Pole Base with Heavy Duty C-Clamp & Grommet .........
CONF-PB-28HDCCG-S
Single Pole Mount Adaptor ...................................................
CONF-ADPT-SPM-S
Dual Pole Mount Adaptor ......................................................
CONF-ADPT-DPM-S
Quick Release Adaptor ..........................................................
MON-ADPTVQR-W-B
Technical Support: Please call Workrite Technical Support while at the Workrite product. (800) 969-9675 option 2.
Hook & Loop
Strips
Hook
& Loop
Strips
High
point
Off
On
6
b
b
c
c
a
a
✓
