3 of 4
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Monitor Capacity Adjustment (Silver Bolts)
If your monitor is too light or too heavy for the factory-
set capacity, the arm will raise, lower or tilt too easily. If
this is the case, you need to adjust the tension.
Adjusting Arm Capacity
To increase ca) turn counter-clockwise using a
5 mm Allen wrench (included with base) until the arm
reaches a balanced adjustment.
To decrease capacity(-) turn clockwise until the arm
reaches a balanced adjustment.
Adjusting Tilt Capacity
To increase ca) turn clockwise using a 5 mm
Allen wrench (included with base) until the monitor
reaches a balanced adjustment.
To decrease capacity(-) turn counter-clockwise until
the monitor reaches a balanced adjustment.
Repeat for other arm.
Adjusting Pivot Tension (Black Bolts)
Setting Tension
If the arm is loose, turn the adjustment screw clockwise using
a 5 mm Allen wrench (included with base) until the arm is tight
and pivots smoothly.
If the arm is tight and does not pivot, turn the adjustment screw
counter-clockwise until the arm pivots smoothly.
Repeat for other arm.
Place Pivot Cover Caps (E) on both arms.
Locking Tension
Tighten the two pre-installed set screws with 2.5 mm Allen
wrench (included with base) on the Dual Arm Adaptor to secure
the arm to the Adaptor.
Loosen
Tighten
4
b
a
a
b
Tilt capacity
Arm capacity
c
5
b
a
a
b
E
c
c
Pre-installed
Set Screws
