5 of 7
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Attach the Manual Release
Do not remove the safety tag or activate the Manual Release
Trigger. Serious injury or damage may occur!
If you have a Workrite worksurface:
Position the Manual Release over the pilot holes near front edge of worksurface.
If you do not have a Workrite worksurface:
Align the Manual Release so the trigger is ¼" in from the edge of worksurface and the cable loops freely from the
Base Assembly. Mark and pre-drill screw pilot holes into underside of worksurface with 3⁄32" drill bit.
Do not drill any more than ¾" deep and
damage your worksurface top!
Attach Manual Release with the four #8 × ⅝"
Pan Head Screws (H) using the #2 Phillips
head driver.
Attach cable to worksurface with
Cable Loop (I) using the one
#8 × ⅝”
Pan Head Screw and a
#2 Phillips driver.
DO NOT ACTIVATE MANUAL RELEASE!
Activation of the Manual Release at this
point may result in serious injury or
damage to your workcenter!
front
Attach Feet
Attach Feet (C) to bottom of legs with #M8 × 16 mm Socket Head Foot Screws (J), using the Allen Wrench and
tighten securely.
Be sure the longer end of the foot faces towards the front of the workcenter.
H
H
a
a
J
b
b
c
c
7
C
C
8
a
I
front
