or
Magnetic
2 of 7
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Verify that you have all the hardware and tools needed for the assembly.
Check your cartons against the list on page 2 to verify that you have all the parts needed. You will also need the
following tools:
#2 tip Phillips screwdriver or drill/driver with magnetic-bit
#3 tip Phillips screwdriver or drill/driver with magnetic-bit
5 mm Allen wrench
⅜” ratchet
If you do not have a Workrite worksurface, you will also need a:
Reversible drill/driver with magnetic-bit
⅛” drill bit
3
⁄
32
” drill bit
Lay Base Assembly (B) on the floor. Remove tape and protective
wrapping on both legs.
Unfold Legs and remove the Cover Plate
Legs are hinged and will fold up to a vertical
position to allow removal of the cover plate.
Access the inside of the Base Assembly by carefully
lifting the Cover Plate.
Note: Careful not to bend the corner tabs. You will
need to lift the assembly slightly to avoid bending
the tabs. Take caution that the legs don’t fall down
while doing performing this step.
2
1
a
b
Caution must be taken to assure
the tabs located at the far sides
of the cover plate are not bent
during removal!
a
a
b
b
