7 of 8 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
6.1
Locate the small P-Loops (R) in the hardware kit (there are two sizes, large and small).
6.2
Open small P-Loops (R) and feed the Switch and Motor Cables into them at the screw hole positions provided.
6.3
Utilizing the #8 x ⅝" (N) wood screws, fasten each P-Loop down to the worksurface at the pre-drilled hole locations.
CABLE MANAGEMENT
7.1
With assistance (a two person job), rotate the Advent workstation onto its back (Modesty Panel side). Utilize a blanket
or other soft material to protect the surfaces from scuffing or marring.
7.2
Continuing with the same assistance (two person job), rotate the Advent onto it feet in a fully upright position
7.3
Locate the Power Module (S).
7.4
Remove the thumb knobs and mounting brackets from each side of the Power Module (S).
7.5
Insert the Power Module (S) into the slot on the right side of the worksurface from the top. The power cord extending
from the Power Module (S) should be pointing to the right and should be fed through the slot first.
7.6
Place each of the mounting brackets over the Power Module (S) studs and the corresponding thumb knob and tighten.
7.7
Adjust the foot glides at each corner of the Advent to level the worksurface. Adjustment may require use of pliers.
TURN WORKSTATION UPRIGHT & INSTALL POWER MODULE
CAUTION:
Lifting or rotating the Advent requires two people to prevent injury.
6
7
