ON/OFF TRIGGER
POLISHING
SPEED CONTROL DIAL
SPINDLE LOCK BUTTON
OPERATION INSTRUCTIONS
11
Press the ON/OFF trigger to turn the unit ON.
Release it to turn the unit OFF.
The speed control dial features 5 settings
(numbered 1 to 5 on the dial), allowing you to
increase or decrease speed from 1,500 to 4,000
RPM. Optimal speed setting for each application is
dependent on work surface and personal
preference; however manufacturer recommends
using lower settings for waxing/polishing and
higher settings for sanding. As a rule, when
sanding, you will generally want to use a higher
setting on harder materials and lower setting on
softer materials. It is also recommended that you
first experiment on a piece of scrap of the same
material as your work surface to determine what
gives you the best combination of finish quality and
removal rate for your application.
A spindle lock button has been provided for locking
the spindle of your tool in a stationary position.
Depress and hold the lock button while installing,
changing, or removing accessories.
1.
Make sure the surface to polish has been thoroughly
washed, and is free of dust, dirt, oil, grease, etc.
2.
Place a clean foam pad (sold separately) securely
Onto the backing pad.
3.
Apply about two tablespoons of wax (not included)
Evenly on the clean foam pad.
CAUTION!
Do not apply the wax directly to the surface of
the vehicle. The amount of wax needed will vary
according to the size of the vehicle being waxed.
NOTICE:
Only use the slower speeds for polishing.
Otherwise, damage may occur to the paint being
polished.
WORKPRO
Tools is not responsible for
damage to the vehicle’s finish due to improper use of
this polisher/sander.
Rotate the Speed Dial to select the desired speed
between 1 and 5.
Plug the power cord into an electrical extension
cord (not included). Then, plug the extension cord
into a grounded, GFCI-protected, 120 volt electrical
outlet.
4.
5.
2
3
