WORKMASTER GO-A8-PW, Руководство по обслуживанию и запасным частям

Страница: 13 / 32

PH: 866.476.9217 9
VIII. DISASSEMBLING THE IMPACTOR
To disassemble the Impactor refer to
Section XI: Impactor Exploded View while
completing the following steps:
1. Remove six (6) Bolts [21] from Head Cover [33] and Motor Casing [20] .
2. Separate Head Cover [33] from Motor Casing [20] .
3. Remove eight (8) Bolts [2] from Hammer Casing [1] and Motor Casing [20] .
4. Separate Hammer Casing [1] from Motor Casing [20] and Separator [19] .
(Cone Bearing [18] and Anvil Rear Spacer [17] can be easily removed at this
point.)
5. Remove internal parts from Hammer Casing [1] .
6. With a soft face hammer, tap spline end of Rotor [27] , until Rotor and
Cylinder Plate [26] with Ball Bearing [25] and Notch Key [31] are free of
Motor Casing [20] .
7. With Arbor Press or similar, remove Rotor [27] from Cylinder Plate [26] and
remove all nine (9) Rotor Blades [28] from Rotor.
8. CAREFULLY remove the Press Fit Ball Bearing [25] from Cylinder Plate [26] .
9. Remove Reverse Valve [35] , by completely removing Reverse Lever Set
Screw [39] from Reverse Lever [36] .
IMPORTANT
If Cylinder [29] or Cylinder Plate [26] show
signs of wear (rust, scoring, etc) Motor Casing
[20] may need to be heated for Cylinder and
Plate removal.