Workhorse Luminator, Руководство пользователя

Страница: 16 / 17

16
Setting Interval Timer: In modes 1 – 3, the device functions as a simple countdown timer. When you set the value, press the Start/
Resume button. When the value reaches 0, the relay is turned OFF and the beeper beeps 6 sets of 2 (250ms) beeps.
To enter one of the 3 countdown modes, press and hold the Mode button for 1 second. Holding down this button the mode will
switch every 2 seconds. Each time the mode switches, the appropriate LED of mode LEDs will be turned ON and the value displayed
will change to the modes default value. An audible ¼ beep will also be heard.
Once the countdown value has been set, you can now start the timer by pressing the Start/ Resume button, the relay is turned ON.
While the timer is counting down the user can stop the event by pressing the Stop button. The current countdown value will
remain on the display. If you want to resume the session you just need to press the start button again. Counting will proceed from
the point where stopped. During this operation, the “run” LED blinks once a second. Once the timer has counted down to 0 and
stopped, you can execute the same session (time value) by pressing the [START/RESUME] button again. This will recall the timer
value and display it. At this point, you have two options. The first being the ability to change the value by using the Increase or
Decrease buttons and the second being the ability to use the same value and starting the event again by pressing the
Start/ Resume button.
Mode 1: 0 – 99 second: DEFAULT DISPLAY = .01
Mode 2: 0 – 99 minute: DEFAULT DISPLAY = 00.00
Mode 3: 0 – 99 hour: DEFAULT DISPLAY = 00.00
Repeat Feature: the timer will remember the last time set. To change the setting from the original setting, press start switch to
recall previous setting then input new setting.
Before using exposure unit for the first time obtain an exposure calculator from your supplier.
Timer settings and programming: