7
9. Begin/ End Production:
Begin Production is used when first starting a production run. Engage Auto Start, then push Production
Begin/End Button within 3 seconds. The pallet table will rotate and activate each head in turn as it proceeds around. When all
heads have begun printing Auto Mode automatically begins.
End Production:
When finishing with a run, load your last shirt at Load
On Station and push Production Begin/End Button. As the machine indexes, each head will deactivate in turn after printing and the
machine will stop when the last shirt is completed.
10. Auto On/ Off: ON;
Will start the printer into production run (flood, rotate and print). The table will begin rotation within 3
seconds of switching to Auto/On. Speed is controlled by the delay timer or the foot switch.
OFF;
In the manual stop position the
table may be raised and lowered using the
Table Up/Down Switch
. The table can be rotated manually by hand. To print a desired
head, select the number of the appropriate head and push that number switch. The table must be in the down position when
printing a head.
11. Fuse:
Used for circuit/ equipment protection if a fault occurs. For trouble shooting see question #1 in the FAQ section.
12. Power Indicator:
Inline with the fuse above it, if a fault occurs blowing the fuse this light will be off. Under normal conditions
this light will be on for the entire duration the press is on.
13. Main Power Switch: On Position:
110 Volt is supplied to the DC converter, computer and main air valve supplying air to the
system.
Off Position:
Power is cut to main controls and air is released through main dump valve. (
Note it is very important the
table be in the proper alignment before energizing the main power switch
).
14. Counter:
Reset before each production run to keep track of the number of shirts printed.
15. Foot Pedal On/ Off: On position
: To begin the production cycle, push the foot pedal down. When each print cycle is completed,
the foot pedal must again be depressed in order for the cycle to start.
Off Position:
The delay Timer will energize and control the
start of the next cycle.
16. Print Timer:
This timer controls the time the pallets will remain in the up position while printing. Set the knob to the number
that allows the slowest squeegee to complete its print stroke before the table lowers.
17. Delay Timer:
After the print cycle is completed, the pallet table will lower and delay timer will be energized. Adjust the knob to
the desired time for loading and unloading between print cycles. After the preset time is reached the table will rotate and begin the
next print cycle. The delay timer is calculated in 1=1 sec.
18. Flood Timer:
This timer controls the time the pallets will remain in the up position while printing. Set the knob to the number
that allows the slowest squeegee to complete its print stroke before the table lowers.
Questions? Give us a call!
800.778.8779
workhorseproducts.com
Visit our website at
Содержание Freedom 6/8
