WORKHORSE CUSTOM CHASSIS
Service Manual
2007 W Series
SECTION
7.2
PAGE
464
Automatic Transmission – Allison
2007 W Series Chassis
© 2006 Workhorse Custom Chassis — All Rights Reserved
WSM082106
• Remove the torque converter bolts.
• Rotate the torque converter one bolt position.
NOTICE:
Use the correct fastener in the correct location.
Use the correct fastener in the correct location.
Replacement fasteners must be the correct part number
Replacement fasteners must be the correct part number
for that application. Fasteners requiring replacement or
for that application. Fasteners requiring replacement or
fasteners requiring the use of thread locking compound
fasteners requiring the use of thread locking compound
or sealant are identified in the service procedure. Do
or sealant are identified in the service procedure. Do
not use paints, lubricants, or corrosion inhibitors on fas-
not use paints, lubricants, or corrosion inhibitors on fas-
teners or fastener joint surfaces unless specified. These
teners or fastener joint surfaces unless specified. These
coatings affect fastener torque and joint clamping force
coatings affect fastener torque and joint clamping force
and may damage the fastener. Use the correct tighten-
and may damage the fastener. Use the correct tighten-
ing sequence and specifications when installing fasten-
ing sequence and specifications when installing fasten-
ers in order to avoid damage to parts and systems.
ers in order to avoid damage to parts and systems.
• Install the torque converter bolts and tighten the
bolts to 60 N•m (44 lb ft).
• Install the starter motor and starter motor bolts.
Refer to Starter Motor Replacement in Engine
Electrical.
CAUTION:
Before servicing any electrical component,
the ignition and start switch must be in the
OFF or LOCK position and all electrical loads
must be OFF, unless instructed otherwise
in these procedures. If a tool or equipment
could easily come in contact with a live
exposed electrical terminal, also disconnect
the negative battery cable. Failure to follow
these precautions may cause personal injury
and/or damage to the vehicle or its compo-
nents.
• Connect the battery.
• Start the vehicle and test for vibration again.
CAUTION:
Before servicing any electrical component,
the ignition and start switch must be in the
OFF or LOCK position and all electrical loads
must be OFF, unless instructed otherwise
in these procedures. If a tool or equipment
could easily come in contact with a live
exposed electrical terminal, also disconnect
the negative battery cable. Failure to follow
these precautions may cause personal injury
and/or damage to the vehicle or its compo-
nents.
6. Disconnect the battery.
7. Raise the vehicle. Refer to Lifting and Jacking the
